GE PVM9195SFSS Installation Instructions - Page 8
PLACEMENT OF THE MOUNTING PLATE, Installation Instructions - lighting
View all GE PVM9195SFSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Installation Instructions 1 PLACEMENT OF THE MOUNTING PLATE A REMOVING THE OVEN FROM 7+(&$57215(029,1* THE MOUNTING PLATE 1 Remove the box containing the installation instructions, filters, exhaust adaptor, damper and the small hardware bag. Do not remove the foam packing protecting the front of the oven. 2 Fold back all 4 carton flaps fully against carton sides. Then carefully roll the oven and carton over onto the top side. The oven should be resting in the foam packing. B ),1',1*7+(:$//678'6 Wall Studs Center Carton Foam packing 3 Pull the carton up and off the oven. 4 The mounting plate is attached to the back of the oven. Remove the two screws holding it to the oven. The plate will be used as the rear wall template and for mounting the oven to the wall. 5 Set the oven upright. Remove and properly discard plastic bags and foam packing. 6 Open the oven door and remove the foam pack from inside the oven. Remove the tape covering the turntable hub. 1 Find the studs, using one of the following methods: A. Stud finder - a magnetic device which locates nails. OR B. Use a hammer to tap lightly across the mounting surface to find a solid sound. This will indicate a stud location. 2 After locating the stud(s), find the center by probing the wall with a small nail to find the edges of the stud. Then place a mark halfway between the edges. The center of any adjacent studs should be 16s or 24s from this mark. 3 Draw a line down the center of the studs. IMPORTANT: The microwave must be connected to at least one wall stud. 8