GE RVM1535DMWW Owners Manual - Page 32

Helpful Information Light Bulb Replacement Cooktop Light Replace the burned-out bulb with a 120 volt, 40-watt incandescent bulb (WB36X10003), available from your GE supplier. 1 To replace the bulb, first disconnect the power at the main fuse or circuit breaker panel or pull the plug. 2 Remove the screw from light cover and lower the cover. 3 Be sure the bulb is cool before removing. After breaking the adhesive seal, remove the bulb by gently turning. 4 Replace the bulb. Close the light cover and secure the cover with the screw. Connect electrical power to the oven. Remove Screw Oven Light Replace the burned-out bulb with a 120 volt, 40-watt incandescent bulb (WB36X10003), available from your GE supplier. 1 To replace the oven light, first disconnect the power at the main fuse or circuit breaker panel or pull the plug. 2 Remove the front grille by backing out the 3 screws along the top. Slide the grille to the left, then pull straight out. 3 Remove the charcoal filter, if present. Reach into the opening, just right of center. The light bulb is located beneath a light compartment cover. Press and hold the center snap while lifting the tab on the left corner. Remove the cover. Remove the bulb by turning gently. 32 4 Install the replacement bulb. Reinstall the compartment cover and charcoal filter, if present, Reinstall the front grille panel with the 3 original screws. Interior Light Housing 5 Connect electrical power to the oven.