GE SCA1000 Owners Manual - Page 39
Filters, always, To remove, To replace - vent filters
View all GE SCA1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
Cooktop light/ night light Reusable vent filters Removing and cleaning the filters Care and Cleaning www.geadvantium.com 1. To replace the cooktop light/ night light, first disconnect the power at the main fuse or circuit breaker panel. 2. Remove the screw from the side of the light compartment cover and lower the cover until it stops. 3. Be sure the bulb to be replaced is cool before removing. Gently pull the bulb from the receptacle. Replace with a 12 volt, 20-watt halogen bulb. Order WB36X10176 from your GE supplier. 4. Raise the light cover and replace the screw. Connect electrical power to the oven. Remove screw The metal filters trap grease released by foods on the cooktop. They also prevent flames from foods on the cooktop from damaging the inside of the oven. For this reason, the filters must always be in place when the hood is used. The vent filters should be cleaned once a month, or as needed. To remove, slide them to the rear using the tabs. Pull down and out. To clean the vent filters, soak them and then swish around in hot water and detergent. Don't use ammonia or ammonia products because they will darken the metal. Light brushing can be used to remove embedded dirt. Rinse, shake and let dry before replacing. To replace, slide the filters into the frame slots on the back of each opening. Press up and to the front to lock into place. 39