GE WSM2780WWW Use and Care Manual - Page 9
How To Operate Your Dryer
View all GE WSM2780WWW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
HOW TO OPERATE YOUR DRYER WARNING-To reduce the risk of fire, electric shock, or injury to persons, read the IMPORTANT SAFETY INSTRUCTIONS before operating this appliance. Delicate 10 AIR FLUFF (HEAT OFF) LOW HEAT 30 50 OFF MORE DRY DRYNE Auto Dry MEDIUM HEAT SS LESS DRY OFF OFF 10 30 50 1 90 70 Timed Dry HIGH HEAT Start 2 Load the dryer properly • Load sorted clothes into dryer. See Loading section. • Clean lint filter before each load. Remove the lint filter by pulling straight up. Wipe all accumulated lint from screen. Properly reposition lint filter after cleaning. Occasionally wash filter using soap and warm water. Rub lightly, rinse and dry thoroughly. This will help remove all fabric softener buildup. Set the controls See the Controls Setting Guide. 1 Turn Cycle Selector clockwise to desired cycle and select correct dryness level or drying time for load type. 2 Press the Start button. (Opening door during operation stops dryer. To re-start, close door and press the Start button again.) Do not use dryer-applied fabric softeners unless you follow these lint cleaning instructions. Do not operate dryer without lint filter in place. • Close door. Door must be closed before dryer will operate. Operating Your Spacemaker Appliance Polyester Knits & Perm Press Drying Tips • Do not overload-Garments being dried or dewrinkled should tumble freely. • Remove clothes immediately-To help prevent wrinkling, remove clothes from the dryer immediately at the end of the drying cycles. • Place on hangers-Permanent Press and Polyester Knit garments look best if placed on hangers after drying. How Timed and Automatic Drying Differ Automatic drying-The Automatic Dry Control system continually senses air temperature in dryer drum. Wet laundry keeps this air cool. When drum air is warm enough, heat turns off. When the air cools, heat turns back on. This on and off cycling may happen a number of times (depending on the fabric, load size and Cycle Selector setting). The Cycle Selector advances (when the heat is off) until it automatically turns dryer off. Timed drying-You select the number of minutes you wish the dryer to run and it turns off at the end of this time period. Dryness Guide for the Automatic Cycle Set to Middle Position OFF MORE DRY DRYNE • For most normal loads. Auto Dry MEDIUM HEAT SS LESS DRY Set toward MORE DRY OFF MORE DRY DRYNE SS • For loads that include heavyweight Auto Dry fabrics. MEDIUM HEAT • If you desire to remove more moisture. LESS DRY Set toward LESS DRY OFF MORE DRY DRYNE SS OFF • For most normal loads. Auto Dry • For very small loads. (Add two or MEDIUM HEAT more similar articles, even if dry, to assist tumbling.) LESS DRY • If you desire to remove less moisture. OFF 9