GE asm10ak User Manual - Page 5

Safety Instructions Operating Instructions Installation Instructions Troubleshooting Tips Consumer Support Additional controls and important information. ge.com Do Not Operate in Freezing Outdoor Conditions This cool-only air conditioner was not designed for freezing outdoor conditions. It must not be used in freezing outdoor conditions. When the air conditioner is turned on, it will automatically start in the setting last used. Power Outage Recovery Feature In the case of a power outage or interruption, the unit will automatically re-start in the settings last used after the power is restored. The Timer and Sleep features will reset to the original setting. You may need to set a new time if desired. Cool Mode Use the Cool mode with High (3), Med (2) or Low (1) fan for cooling. Use the Increase v / Decrease w pads to set the desired temperature between 64°F and 86°F in 1°F increments. A thermostat is used to maintain the room temperature. The compressor will cycle on and off to keep the room at the set level of comfort. Set the thermostat at a lower number and the indoor air will become cooler. Set the thermostat at a higher number and the indoor air will become warmer. NOTE: If the air conditioner is off and is then turned on while set to Cool, it will take approximately 3 minutes for the compressor to start and cooling to begin. Cooling Descriptions For Normal Cooling-Select the Cool mode and High (3) or Med (2) fan with a middle set temperature. For Maximum Cooling-Select the Cool mode and High (3) fan with a lower set temperature. For Quieter & Nighttime Cooling-Select the Cool mode and Low (1) fan with a middle set temperature. NOTE: If you switch from a Cool setting to Off or to a fan setting, wait at least 3 minutes before switching back to a Cool setting. Fan Mode Use the Fan at High (3), Med (2) or Low (1) to provide air circulation and filtering without cooling. Since fan only settings do not provide cooling, a temperature setting will not be displayed. Vent Control (on some models) The vent control is located on the inside of the air louvers in the lower right corner. When set at CLOSE, only the air inside the room will be circulated and conditioned. When set at OPEN, some inside air is exhausted outside. OR To open the vent, push the lever to the right. To close it, push it to the left. To open the vent, push the lever to the right. To close it, push it to the left. Air Direction-Up and Down (on some models) Fingertip pressure on the horizontal louvers adjusts the air direction up or down. OR Air Direction-Side-to-Side (on some models) On some models, the side-to-side air direction is adjusted by the louver levers or by grasping and moving the inner vertical louvers. OR 5