Gigabyte GA-990FXA-UD7 Manual - Page 26
SATA3_0/1/2/3/4/5 SATA 6Gb/s Connectors, Controlled by AMD SB950 South Bridge, GSATA3_6/7 SATA 6Gb/s - amd 9
View all Gigabyte GA-990FXA-UD7 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
7) SATA3_0/1/2/3/4/5 (SATA 6Gb/s Connectors, Controlled by AMD SB950 South Bridge) The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA 1.5Gb/s standards. Each SATA connector supports a single SATA device. The AMD SB950 South Bridge supports RAID 0, RAID 1, RAID 5, RAID 10, and JBOD. Refer to Chapter 5, "Configuring SATA Hard Drive(s)," for instructions on configuring a RAID array. SATA3_0 7 7 SATA3_1 G.QBOFM G.QBOFM SATA3_2 SATA3_3 SATA3_4 1 1 SATA3_5 PGin.NQBoO. FMDefinition 1 GND 2 TXP 3 TXN 4 GND 5 RXN 6 RXP 7 GND 8) GSATA3_6/7 (SATA 6Gb/s Connectors, Controlled by Marvell 88SE9172 Chip) EBUG ORT DEBUG PORT The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA 1.5Gb/s standards. Each SATA connector supports a single SATA device. The Marvell 88SE9172 chip supports RAID 0 and RAID 1. Refer to Chapter 5, "Configuring SATA Hard Drive(s)," for instructions on configuring a RAID array. G.QBOFM Pin No. Definition GSATA3_7 7 1 7 1 1 GND 2 TXP 3 TXN 4 GND GSATA3_6 5 RXN 6 RXP 7 GND • A RAID 0 or RAID 1 configuration requires at least two hard drives. If more than two hard drives are to be used, EBUG the total number of hard drives must be an even number. ORT • A RAID 5 configuration requires at least three hard drives. Please connect the L-shaped end of (The total number of hard drives does not have to be an even number.) the SATA cable to your SATA hard drive. • A RAID 10 configuration requires four hard drives. Hardware Installation - 26 -