Gigabyte GA-B75M-D3V User Manual - Page 17

8) F_PANEL (Front Panel Header) Connect the power switch, reset switch, speaker, chassis intrusion switch/sensor and system status indicator on the chassis to this header according to the pin assignments below. Note the positive and negative pins before connecting the cables. Message/Power/ Power Sleep LED Switch Speaker MSG+ MSG- PW+ PWSPEAK+ SPEAK- F_AUDIO(H) F_PANEL(NH) 2 1 20 F_PANEL 19 (H61M-D2) HD+ HD- RESRES+ CICI+ PWR+ PWR- Hard Drive Reset Activity LED Switch Power LED Chassis Intrusion Header •• MSG/PWR (Message/Power/Sleep LED): DB_PORT System Status LED Connects to the power status indicator on the chassis front panel. The LED is S0 On BIOSoSnwiwtchheern(Xt5h8eA-OsyCs) tem is operating. The LED keeps blinking when the system S1 Blinking is1 in S1 sleep state. The LED is off when the system is in S3/S4 sleep state S3/S4/S5 Off or powered off (S5). M_SATA DIP 1 23 1 DIP 1 23 1 DIP 1 23 1 •• PW (Power Switch): Connects to the power switch on the chassis front panel. You may configure the way to turn off youArCsPyI_sCtePmT Voltage measuremeunst imnogduthlee(Xp58oAw-OeCr)switch (refer to Chapter 2, "BIOS Setup," "Power Management," for more infor(mGAa-tIiVoBn)). •• SPEAK (Speaker): PWM Switch (X58A-OC) Connects to the speaker on the chassis front panel. The system reports system startup status by issuing a beep code. One single short beep will be heard if no problem is detected at system startup. If a problem is detected, the BIOS may issuDIPe beeps in different patterns to indicate the problem. •• HD (Hard Drive Activity LED)1:2 3 SMB_CPT (GA-IVB) PCIe power conCnoecntonre(ScAtsTAto)(Xt5h8eA-hOaCr)d drive activity LED on the chassis front panel. The LED is on when the hard drive is reading or writing data. •• RES (Reset Switch): Connects to the reset switch on the chassis front panel. Press the reset switch to restart the computer if the computer freezes and fails to perform a normal restart. CLR_CMOS •• CI (Chassis Intrusion Header): CI DIS_ME Connects to the chassis intrusion switch/sensor on the chassis that can detect if the chassis coGvPe15r_hCaPsT been removed. This function requires a chassis with a chassis intrusion switch/sensor. (GA-IVB) XDP_CPU XDP_PCH (GA-IVB) The front panel design may differ by chassis. A front panel module mainly consists of power switch, reset switch, power LED, hard drive activity LED, speaker and etc. When connecting your chassis front panel module to this header, make sure the wire assignments and the pin assignments are matched correctly. - 17 -