Gigabyte GA-C1037UN User Manual - Page 13
SATA2 1/2 SATA 3Gb/s Connectors, F_PANEL Front Panel Header, Hard Drive Activity LED
View all Gigabyte GA-C1037UN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
5) SATA3 0 The SATA (SATA 6Gb/s Connectors) connector conforms to SATA 6Gb/s DEBUG standaPrOdRTand is compatible with SATA 3Gb/s and SATA 1.5Gb/s standard. Each SATA connector supports a single SATA device. DEBUG SATA3 0 Pin No. DPeOfinRiTtion Pin No. Definition 1 1 GND 5 RXN 2 TXP 6 RXP 3 TXN 7 GND 4 GND 7 6) SATA2 1/2 (SATA 3Gb/s Connectors) The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s standard. Each SATA connector supports a single SATA device. SATA2 21 1 7 1 Pin No. 1 2 3 4 Definition GND TXP TXN GND Pin No. 5 6 7 Definition RXN RXP GND 7 7) F_PANEL (Front Panel Header) Connect the power switch, reset switch, and system status indicator on the chassis to this header according to the pin assignments below. Note the positive and negative pins before connecting the cables. Power Switch Message/ Sleep LED •• MSG (Message/Sleep LED): PWPW+ MSGMSG+ 10 9 21 NC RES+ RESHDHD+ Reset Switch Hard Drive Activity LED System Status LED S0 On S3/S4/S5 Off Connects to the power status indicator on the chassis front panel. The LED is on when the system is operating. The LED is off when the system is in S3/S4 sleep state or powered off (S5). •• PW (Power Switch): Connects to the power switch on the chassis front panel. You may configure the way to turn off your system using the power switch (refer to Chapter 2, "BIOS Setup," "Power Management," for more information). •• HD (Hard Drive Activity LED): Connects to the hard drive activity LED on the chassis front panel. The LED is on when the hard drive is reading or writing data. •• RES (Reset Switch): Connects to the reset switch on the chassis front panel. Press the reset switch to restart the computer if the computer freezes and fails to perform a normal restart. •• NC No connection. The front panel design may differ by chassis. A front panel module mainly consists of power switch, reset switch, hard drive activity LED and etc. When connecting your chassis front panel module to this header, make sure the wire assignments and the pin assignments are matched correctly. - 13 -