Gigabyte GA-F2A88XM-HD3P User Manual - Page 34

Deleting an Array The Delete Array(s) menu option allows for deletion of disk array assignments. 1. Select Delete Array(s) in the Main Menu and press . 2. In the Arrays section, press the key on the array you want to delete and then press to proceed. 3. When prompted to confirm, press to continue the deletion or to cancel. Deleting an existing disk array could result in loss of data. Record all array information including the array type, the disk members, and stripe block size in case you wish to undo a deletion. Installing the SATA RAID/AHCI Driver and Operating System With the correct BIOS settings, you are ready to install the operating system. A. Installing Windows Step 1: You need to install the SATA RAID/AHCI driver during the OS installation. Use an alternative system to copy the SATA RAID/AHCI driver from the motherboard driver disk to a USB flash drive. Copy the SATA RAID/AHCI driver folder under BootDrv in the driver disk depending on your Windows version, for example: Windows 10 driver folder: "BootDrv\Hw10" Windows 8.1 driver folder: "BootDrv\Hw81" Windows 7 driver folder: "BootDrv\Hw7_A88" Step 2: Boot from the Windows 8.1 setup disk and perform standard OS installation steps. When the screen requesting you to load the driver appears, select Browse. Step 3: Then browse to the USB flash drive and select the location of the driver, for example: Windows 10 64-bit RAID driver directory: "Hw10\RAID\x64" Windows 8.1 64-bit RAID driver directory: " Hw81\RAID\x64" Windows 7 32-bit RAID driver directory: "Hw7_A88\RAID\x86" Step 4: When a screen as shown in Figure 1 appears, select AMD-RAID Controller and click Next to load the driver and continue the OS installation. Please visit GIGABYTE's website for details on configuring a RAID array. - 34 -