Gigabyte GA-H67N-USB3-B3 Manual - Page 24
SATA3_0/1 SATA 6Gb/s Connectors, Controlled by Intel H67 Chipset
UPC - 818313012432
View all Gigabyte GA-H67N-USB3-B3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
6) SATA3_0/1 (SATA 6Gb/s Connectors, Controlled by Intel H67 Chipset) The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA 1.5Gb/s standard. Each SATA connector supports a single SATA device. The SATA3_0 and SATA3_1 connectors support RAID 0 and RAID 1. RAID 5 and RAID 10 can be implemented on the two con- nectors with the SATA2_2/3 and eSATA connectors . (Note) Refer to Chapter 5, "Configuring SATA Hard Drive(s)," for instructions on configuring a RAID array. Pin No. Definition SATA3_0 1 SATA3_1 7 1 GND 2 TXP 3 TXN 4 GND 5 RXN 6 RXP 7 GND 7) SATA2_2/3 (SATA 3Gb/s Connectors, Controlled by Intel H67 Chipset) The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s standard. Each SATA connector supports a single SATA device. The Intel H67 Chipset supports RAID 0, RAID 1, RAID 5 and RAID 10. Refer to Chapter 5, "Configuring SATA Hard Drive(s)," for instructions on configur- ing a RAID array. Pin No. Definition 1 GND 2 TXP SATA2_2 1 SATA2_3 7 3 TXN 4 GND 5 RXN 6 RXP 7 GND DEBUG PORT DEBUG PORT DEBUG PORT DEBUG PORT Please connect the L-shaped end of the SATA cable to your SATA hard drive. •• A RAID 0 or RAID 1 configuration requires at least two hard drives. If more than two hard drives are to be used, the total number of hard drives must be an even number. •• A RAID 5 configuration requires at least three hard drives. (The total number of hard drives does not have to be an even number.) •• A RAID 10 configuration requires four hard drives. (Note) When a RAID set is built across the SATA 6Gb/s and SATA 3Gb/s channels, the system perfor- mance of the RAID set may vary depending on the devices being connected. Hardware Installation - 24 -