Gigabyte GA-MA790FX-DQ6 Manual - Page 28
GSATAII_1/GSATAII_2 SATA 3Gb/s Connectors, Controlled by GIGABYTE SATA2, Purple, PWR_LED System
View all Gigabyte GA-MA790FX-DQ6 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
English 11) GSATAII_1/GSATAII_2 (SATA 3Gb/s Connectors, Controlled by GIGABYTE SATA2, Purple) The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s standard. Each SATA connector supports a single SATA device. The GIGABYTE SATA2 controller supports RAID 0 and RAID 1. Refer to Chapter 5, "Configuring SATA Hard Drive(s)," for instructions on configuring a RAID array. Pin No. Definition 1 GND 2 TXP 3 TXN 4 GND 5 RXN 7 17 1 6 RXP GSATAII_1 GSATAII_2 7 GND Please connect the L-shaped end of the SATA 3Gb/s cable to your SATA hard drive. A RAID 0 or RAID 1 configuration requires two hard drives. 12) PWR_LED (System Power LED Header) This header can be used to connect a system power LED on the chassis to indicate system power status. The LED is on when the system is operating. The LED keeps blinking when the system is in S1 sleep state. The LED is off when the system is in S3/S4 sleep state or powered off (S5). Pin No. Definition 1 MPD+ 2 MPD- 1 3 MPD- System Status LED S0 On S1 Blinking S3/S4/S5 Off GA-MA790FX-DQ6 Motherboard - 28 -