Gigabyte GA-MA790FXT-UD5P Manual - Page 88
Application Software
View all Gigabyte GA-MA790FXT-UD5P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 88 highlights
Smart Backup Config Apply RAID Config CMOS Setup Utility-Copyright (C) 1984-2009 Award Software Smart Backup Config [Performance (RAID 0)] [Press Enter] Item Help Menu Level === Disk Info === [Port] [Model] Port 0 WDCWD800JD-00JNA0 Port 1 WDCWD800JD-22LSA0 [Capacity] 80GB 80GB === RAID Info === [Level] [Capacity] [Member] Performance 0GB Move Enter: Select F5: Previous Values +/-/PU/PD: Value F10: Save F6: Fail-Safe Defaults Figure 2 ESC: Exit F1: General Help F7: Optimized Defaults Step 4: After configuring the SATA ports, you are ready to proceed with the installation of the operating system. You do not have to load the SATA controller driver during the installation process of the operating system. Make sure to install the driver after the operating system is installed (using "Xpress Install" to install all drivers required for your motherboard is recommended) for the SATA hard drives to work and be detected properly. Step 5: Then install the Smart Backup utility from the Application Software menu on the driver Autorun screen for monitoring the device/RAID status in the operating system (for more information, refer to section 51-5, "Smart Backup Utility"). GA-MA790FXT-UD5P Motherboard - 88 -