Gigabyte MD30-RS0 Manual - Page 23
SATA 6Gb/s Connectors/SATA0 Support SATA DOM Function, SSATA0/SSATA1/SSATA2/SSATA3 SATA 6Gb/s
View all Gigabyte MD30-RS0 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
12/13) SATA0/SATA1/SATA2/SATA3/SATA4/SATA5 (SATA 6Gb/s Connectors/SATA0 Support SATA DOM Function) 14) SSATA0/SSATA1/SSATA2/SSATA3 (SATA 6Gb/s Connectors) The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and 1.5Gb/s standard. Each SATA connector supports a single SATA device. Please see page 34 for SATA DOM jumper setting. 7 1 Normal Mode: SATA DOM Mode: SSATA3 SSATA1 SSATA2 SSATA0 SATA5 SATA1 SATA4 SATA0 SATA3 SATA2 Pin No. 1 2 3 4 5 6 7 Definition GND TXP TXN GND RXN RXP GND Pin No. 1 2 3 4 5 6 7 Definition GND TXP TXN GND RXN RXP P5V • A RAID 0 or RAID 1 configuration requires at least two hard drives. If more than two hard drives are configured, the total number of hard drives must be an even number. • A RAID 10 configuration requires four hard drives. (Note) When a RAID configuration is built across the SATA 6Gb/s channels, the system performance of the RAID configuration may vary depends on the devices are connected. 15/16) SSATA_SGP/SATA_SGP (SATA SGPIO Headers) SGPIO stands for Serial General Purpose Input/Output which is a 4-signal (or 4-wire) bus used between a Host Bus Adapter (HBA) and a backplane. Out of the 4 signals, 3 are driven by the HBA and 1 is driven by the backplane. Typically, the HBA is a storage controller located inside a server, desktop, rack or workstation computer that interfaces with Hard disk drives (HDDs) to store and retrieve data. 87 2 8 1 7 21 SSATA_SGP SATA_SGP Pin No. 1 2 3 4 5 6 7 8 Definition DATAIN No Pin DATAOUT GND GND LOAD NC CLOCK Hardware Installation - 23 -