Graco 1750714 Owners Manual - Page 34
Installing the Infant Restraint and Base, Using Vehicle Belt
UPC - 047406102730
View all Graco 1750714 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
3. Buckle the vehicle belt. Make sure the buckle tongue goes belt should into not the be tcworirsetcetdbuocrktleurne. dT.he seat 4. Tighten the vehicle seat belt. Refer to your vehicle ownerÊ s manual and the instructions in „ 6.2.2 SAFE Vehicle Belt Systems‰ , page.29-31, on tightening your vehicle belt when using the infant restraint without base. To create a secure installation, push down hard with your free hand on the infant restraint and pull and tighten the vehicle belt. 5. Test infant restraint for secure installation as described in infant restraint „ Final Safety Check‰ page.40. 7.2 Installing the Infant Restraint and Base Using Vehicle Belt When using the base to install the infant restraint, the lock-off is ALWAYS used to secure both belts of the lap or lap/shoulder belt. 1. Place the base in a rear-facing position on a vehicle seat. Lock-off 2. Open the lock-off and route the vehicle belt through the belt path and over the lock-off. 34