Haier 2HUM14HC03 User Manual - Page 6

Indoor Unit Installaion Necessary Tools for Installation ƽ Driver ƽ Nipper ƽ Hacksaw ƽ Hole core drill ƽ Spanner(17,19 and 26mm) ƽ Gas leakage detector or soap-and-water solution ƽ Torque wrench (17mm,22mm,26mm) ƽ Pipe cutter ƽ Flaring tool ƽ Knife ƽ Measuring tape ƽ Reamer Power Source ƽ Before inserting power into receptacle, check the voltage without fail. ƽ The power supply is the same as the corresponding nameplate. ƽ Install an exclusive branch circuit of the power. ƽ A receptacle shall be set up in a distance where the power cable can be reached.Do not extend the cable by cutting it. Selection of Installation Place Accessory Parts ƽ Place, robust not causing vibration, where the body can be supported sufficiently. ƽ Place, not affected by heat or steam generated in the vicinity, where inlet and outlet of the unit are not disturbed. ƽ Place, possible to drain easily, where piping can be connected with the outdoor unit. ƽ Place, where cold air can be spread in a room entirely. ƽ Place, nearby a power receptacle, with enough space around. ƽ Place where the distance of more than lm from televisions, radios, wireless apparatuses and fluorescent lamps can be left. ƽ In the case of fixing the remote controller on a wall, place where the indoor unit can receive signals when the fluorescent lamps in the room are lightened. Remote controller (1) R-03 dry battery (2) Mounting plate (1) Drain hose (1) Plastic cap (4) Ø4X25 Screw (4) Air purifying filter(Optional) (1) Selection of Pipe FOR 07K 09K 12K Drawing for the installation of indoor units The models adopt HFC free refrigerant R410A more than 15 cm Attention must be paid to the rising up of drain hose more than 10cm Arrangement of piping directions Rear left Left Rear right Right Below more than 10cm The distance between the indoor unit and the floor should be more than 2m. Please be subject to the actual product purchased,the above picture is just for your reference. 6