Haier ESAQ406P Manual - Page 14
Preparing The Window
View all Haier ESAQ406P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
ENGLISH PREPARING THE WINDOW 1. Measure the width of the window opening. (See Fig.13) 2. Mark the center line on the inside of the windowsill with a pencil. (See Fig.14) WIDTH OF WINDOW OPENING Fig. 13 CENTER LINE Fig. 14 HEIGHT LENGTH WIDTH WIDTH WIDTH CENTER NOTES AND WARNINGS: • Be sure your air conditioner does not fall out of the window opening during installation or removal. • Do not block the air discharge or air intake areas on the front panel. • Do not block the louvers on the outside of the air conditioner. 3. Center the air conditioner in the window sill. Make sure to place the unit so that it is resting on the windowsill with a ¼" to ½" downward tilt towards the outside. Lower the window sash behind the top channel to hold the unit in place. (See Fig.15) Fig. 15 Top Channel NOTE: The appearance of your model may differ from the one shown. 4. Loosen the screw located on the lower-right hand corner of the air conditioner. 5. Slide the side bracket over the screw. The side bracket should be resting on the window sill. (See Fig.16) 6. Partially tighten the screw. Secure the unit before tightening completely. 7. Use 1/8" drill bit to drill a starter hole through the holes in the side bracket. 8. Using two (2) 1" wood screws, attach the side bracket to the window sill. 9. Repeat for side bracket installation on the left-hand side of the air conditioner. Fig. 16 Lower Window Sash PAGE 12 HOW TO INSTALL