Haier HBU-36CA03 User Manual - Page 22

Clean inlet grill], Clean outlet and shell], Dismantle and install swing, plate ]

Page 22 highlights

MAINTENANCE [Clean inlet grill] 3. Take of inlet grill Open the inlet grill by an angle of 45 , lift up. Don't wash with water over 50 * ,otherwise may cause decoloring or deforming. Use soft dry cloth to scrub. If dust not removed, can use water or neutral detergent. If ceiling built-in conditioner's swing plate too dirty, it can be dimantled (as described below) and cleaned. 4. Clean CAUTION! [Dismantle and install swing plate ] Don't wash with water over 50 * ,to prevent decoloring or deforming. Use soft brush, water and neutrul detergent,1. Fix the swing plate at the bottom. then swing off the water. 2. Dismantle the swing plate. CAUTION! NOTE When too much dust Use water to clean the plate and don't heavily scrub, otherwise the fine hair may fall off. To spray the special detergent for vent fan oUrnscrew the screw at both ends of the swing utensils. plate. 5. Install inlet grilslee 3 6. Install air filtersee "Clean air filter" 7. Close inlet grill see 1 [Clean outlet and shell] CAUTION! Don't use gasoline, benzene, dilutant, polishing powder, or liquid inseticide. 20

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24

MAINTENANCE
20
[Clean inlet grill]
3. Take of inlet grill
Open the inlet grill by an angle of 45 ,
lift up.
4. Clean
CAUTION!
Don't wash with water over 50
*
,to prevent
decoloring or deforming.
Use soft brush, water and neutrul detergent,
then swing off the water.
NOTE
When too much dust
To spray the special detergent for vent fan or
utensils.
5. Install inlet grill
6. Install air filter
7. Close inlet grill
[Clean outlet and shell]
see 3
see "Clean air filter"
see 1
CAUTION!
Don't use gasoline, benzene, dilutant,
polishing powder, or liquid inseticide.
Don't wash with water over 50
*
,otherwise
may cause decoloring or deforming.
Use soft dry cloth to scrub.
If dust not removed, can use water or neutral
detergent.
If ceiling built-in conditioner's swing plate
too dirty, it can be dimantled (as described
below) and cleaned.
[Dismantle and install swing
plate ]
1. Fix the swing plate at the bottom.
2. Dismantle the swing plate.
CAUTION!
Use water to clean the plate and don't heavily
scrub, otherwise the fine hair may fall off.
Unscrew the screw at both ends of the swing
plate.