Haier HPRD12XC7 User Manual - Page 12

English 88hr Control Panel (continued) Power Control The power control turns the unit on and off. Warning Light Condensed water may accumalate in the unit. If the internal tank becomes full, the Warning signal in the LCD Display will light the unit Mode Control The mode control has 3 settings: • Cool • Dehumidifier • Heating (only HPRD12XH7)/Fan The settings are adjusted with 8M8˚oF de Control button. A green light will indic8a8ther which setting is currently being used. Cooling Mode When the cool mode is selected, " " will show in the LCD Display. During the cooling mode the air is cooled and hot air is exhausted to the ou- tiside through the exhaust tube a8d8˚jFust fan speed and air temperature to suit your desired comfort level. 88hr Note: The air exhaust hoses must vent outside the room when using cool mode. Dehumidifier Mode When dhumidify mode is selected, " " will show inthe LCD display. Air is dehumidified as it passes through the unit, without being in full cooling mode. If room temperature is higher than 77˚ 8C8,˚F fan speed can be adjusted: otherwise fan speed is fix8e8d˚F to "Low". Note8:8Thhre warm a88ir˚F exchange hoses must vent inside the ro88ohmr when using Dehumidify Mode, not outside as it d8o8ehsr when cooling. If the unit is vented outside some cooling will occur. Heating Mode (Led in Red) (only HPRD12XH7) In heating mode " ", the air flow is selectable. (Note: Heating is activated only when the ambient temperature is below 77° F.) Fan Speed Control (Led in Yellow) The Fan Speed Control has 3 settings: High, Medium. and low. Timer Auto turn off: With machine in running mode, press timer button for setting timer control. Press " " or " " to select number of hours you would like the unit to run before it automatically shuts off. Auto turn off: With machine in stand by mode, press timer button for setting timer control. Press " " or " " to select number of hours before the unit automatically starts running in air conditioning mode. Note: The time is adjustable between 1-24 hours. Temperature Controls • Used for adjusting the thermostat • The default display is room temperature • In cooling mode, when " " or " " button is pressed, the set temperature is displayed and may be adjusted. After 15 seconds the display will revert back to room temperature. Temperature is only adjustable in cool mode. Note: by pressing both " " / " " buttons at the same time for more than 3 seconds, the display will toggle between Celsius and Fahrenheit. Fan Mode (Led in Yellow) When fan mode is selected will be shown in the LCD display, air is circulated throughout the room with no cooling. 10