Haier HSU-18LEA13 User Manual - Page 7

Parts and Functions Remote controller Display board 1 10 2 6 7 5 8 3 9 23 HEALTH ON/OFF 4 24 13 11 FAN 18 MODE SWING 15 20 TIMER 12 21 CLOCK 14 19 SET SLEEP 16 22 17 LOCK RESET 1. Operation mode display Operation mode AUTOCOOL DRYHEAT FAN Remote controller Display board 2. SWING display 3. FAN SPEED display AUTO LO MED HI 4. SLEEP display 5. LOCK display 6. SIGNAL SENDING 7.TIMER OFF display Clock set 25 1 1 26 23 1 7 8 9 8. TIMER ON display 9. CLOCK display 10. TEMP display 11. POWER ON/OFF Used for unit start and stop. 12. MODE Used to select AUTO run, COOL,DRY HEAT and FAN operation 13. FAN Used to select fan speed LO, MED, HI, AUTO 14. HOUR Used to set clock and timer setting. 15. SWING Used to set auto fan direction. 16. SLEEP Used to select sleep mode. 17. LOCK Used to lock buttons and LCD display. 18. TEMP.SETTING Used to select your desired temp. 19. SET Used to confirm timer and clock settings. 20. TIMER Used to select TIMER ON,TIMER OFF, TIMER ON-OFF 21. CLOCK Used to set correct time 22. RESET Used to reset the controller back to normal condition. 23. HEALTH display 24. HEALTH Used to operate the healthy fu. nction 25. Singal receiver hole 26. Ambient temp.display When receiving the remote control signal, display the set temperature and in the rest time the room temperature is displayed and this room temperature is only for reference. When unit is started for the first time and after replacing batteries in remote controller, clock should be adjusted as follows: Press CLOCK button, "AM" or "PM" flashes. Press or to set correct time. Each press will increase or decrease 1min. If the button is kept depressed, time will change quickly. . After time setting is confirmed,press SET,"AM "and "PM" stop flashing,while clock starts working. NOTE: Cooling only unit do not have displays and functions related with heating Hints After replacing with new batteries, remote controller will conduct self-check, displaying all information on LCD.Then, it will become normal. 6