Haier HSU12XCK User Manual - Page 1

Installation Manual of Room Air Conditioner Preparation Necessary Tools for Installation ƽ Hammer ƽ Nipper ƽ Hacksaw ƽ Hole core drill ƽ Spanner(17,19 and 26mm) ƽ Gas leakage detector or soap-and-water solution ƽ Torque wrench (17mm,22mm,26mm) ƽ Pipe cutter ƽ Flaring tool ƽ Knife ƽ Measuring tape ƽ Reamer Power Source ƽ Before inserting power plug into receptacle, check the voltage without fail. The power source is the same as the corresponding name plate. ƽ Install an exclusive branch circuit of the power. ƽ A receptacle shall be set up in a distance where the power cable can be reached.Do not extend the cable by cutting it. Selection of Installation Place Indoor Unit - Select a location that is ƽ Robust not causing vibration, where the body can be supported sufficiently. ƽ Not affected by heat or steam generated in the vicinity, where inlet and outlet of the unit are not disturbed. ƽ Possible to drain easily, where piping can be connected with the outdoor unit. ƽ Where cold air can be spread in a room evenly. ƽ Nearby a power receptacle. (Refer to drawings). ƽ Place where the distance of more than lm from televisions, radios, wireless apparatuses and fluorescent lamps can be left. ƽ In the case of fixing the remote controller on a wall, place where the indoor unit can receive signals when the fluorescent lamps in the room are in use. Outdoor Unit - Select a location that is ƽ Less affected by rain or direct sunlight and is sufficiently ventilated. ƽ Strong enough to bear the unit, where vibration and noise are not increased. ƽ Not causing a nuisance to neighbors due to discharged air or noise. ƽ A distance marked Q is available as illustrated in the below figure. Drawing for the installation of indoor and outdoor units The models adopt HC FC free refrigerant R410A more than 10cm (3 7/8) more than 10cm (3 7/8) Attention must be paid to the pitch of drain hose G Optional parts for piping A Non-adhesive tape B Adhesive tape C Saddle (L.S) with screws D Connecting electric cable for indoor and outdoor E Drain hose F Heating insulating material G Piping hole cover 256 (10 1/16) 340 (13 1/2) Arrangement of piping directions Rear left Left Rear right Right Below ƽ The marks from A to G in the figure are the parts numbers. ƽ The distance between the indoor unit and the floor should be more than 2m. more than 20cm (7 7/8) more than 60cm (23 5/8) more than 10cm (3 7/8) F A C more than 15cm (5 7/8) D E more than 25cm (9 7/8) The above picture is for your reference only. Your product may look different. Read this manual before installation. Explain the operation of the unit to the user according to this manual. NO.0010536242 Floor fixing dimensions of the outdoor unit (Unit:mm / inch) For:09k 12k 18k 140 (5 1/2) 500 (19 2/3) 140 (5 1/2) For:24k 113.5 (4 1/2) 633 (24 7/8) 113.5 (4 1/2) Fixing of outdoor unit ƽ Fix the unit to concrete or block with bolts (10mm) and nuts firmly and horizontally. ƽ When fitting the unit to wall surface, roof or rooftop, fix a supporter securely with nails or wires in consideration of earthquake and strong wind. ƽ If vibration may affect the house, fix the unit by attaching a vibration-proof mat.