Haier HWD1000 Instruction Manual - Page 21
Troubleshooting - front load washer
UPC - 688057394381
View all Haier HWD1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
English Troubleshooting Washer does not operate: • Check if unit is plugged in. The plug may have come loose. • Check if the electrical wall receptacle has proper voltage. • Check if the circuit breaker needs to be reset or if the fuse needs to be replaced. • Check if the unit is in "Off" mode. • Check if the washer is overloaded: load may need to be re-balanced and clothes may need to be redistributed. • Check if the door is open. You may have to close the door properly. Problems with water: • Not enough water coming out: Water faucet may need to be turned on fully. Water hoses may be tangled up or wrinkled up. Straighten up hoses. Check water level selection, it may need to be readjusted. • Water Temperature is incorrect: Check your water heater temperature. Hot water needs to be at a temperature at least 120˚F-140˚F (49˚C- 60˚C). Check to make sure the inlet hoses are properly connected. (e.g. hot to hot & cold to cold) • Water leaks: This is due to not improperly installed drain hose or fill hoses. Your home drain may be clogged. You may need to tighten hoses, check the plumbing or call a plumber for service. • Water pumped out before the cycle is completed: It happens if you open the door in the middle of cycle. • Water will not drain: This may be because drain hose was not installed properly. Check the position of the drain hose. In order to drain properly, make sure that top of drain outlet is less than 4 ft. (1.2 m) above the floor. 20