Haier RBFS21SIAP User Manual - Page 34

English Problem Cause Solution Automatic icemaker The. icemaker has stopped making ice. • The ice cube height sensor arm has detected a full tray condition. • The water supply valve is closed. • The freezer section is not cold enough. • To make more ice cubes you may need to distribute your ice to the center drawer right side (or lower drawer) to increase ice cube harvest volume. • Turn on the water supply valve. • Adjust the setting in the freezer to colder setting and allow it to balance within 24 hours. • Check the water supply. • The water source saddle saddles valve for obstruction valve is somehow blocked. and replace it if damaged. The ice. making capacity is low. • The freezer drawer area is not cold enough. • The water supply valve is not high enough pressure or does not open all the way. • The icemaker sensor arm is restricted or out of. position. • Set the freezer drawer to a colder setting. • Make sure the water pressure is between 25-121 psi and add water booster if too low. • Make sure the water valve. supply is open all the way. • Make sure the water filter is distributing enough water and is not clogged. • Make sure the drawer gaskets are sealing and kept clean from dirt and debris. The. • The icemaker level sensor icemaker is stuck in the down. runs. position. continuously. • Check the movement of the. icemaker sensor arm so it rests in the "up" position. • Make sure no frozen packs or objects are obstructing the. icemaker sensor arm. 33