Hamilton Beach 14200 Use & Care - Page 5
Fabric Setting Chart
UPC - 040094142002
View all Hamilton Beach 14200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
840141100 ENv02.qxd 9/22/05 1:39 PM Page 5 Fabric Setting Chart Steam Setting Steam Range Dry Iron Temperature Setting Off ( O ) Nylon, • Acrylic Silk • Polyester •• Wool •• Rayon ••• Cotton, ••• Linen Ironing Instructions Dry iron using spray if necessary. Dry iron on the wrong side of the fabric. Iron while fabric is still damp. Use a press cloth and steam iron on the wrong side of fabric. Iron using spray if necessary. For cotton, iron while still damp or use spray. For linen, iron fabric on wrong side. Caring for Your Iron Iron 1. The water tank of your iron should be emptied after each use. Turn Temperature Control Dial to OFF ( O ). Unplug the iron and hold over a sink. Slowly tilt pointed end of iron down over sink. Water will run out of water tank opening. 2. After iron has completely cooled, wrap cord loosely around the iron and store in an upright position. Do not store iron laying flat on soleplate. Soleplate 1. Never iron over zippers, pins, metal rivets, or snaps, as these may scratch the soleplate. 2. To clean occasional build-up on the soleplate, wipe with a sudsy cloth. Do not use abrasive cleansers or metal scouring pads. 3. Always store iron upright in the heel rest position. Self-Clean To keep the steam vents clear of any build-up, follow these instructions each time you iron using steam. 1. Turn Temperature Control Dial to OFF ( O ) and set Adjustable Steam Switch to Dry Iron . Fill iron with water to 1⁄2 of its maximum capacity. 2. Turn Temperature Control Dial to Linen setting and let iron heat for 2 minutes. Keep Adjustable Steam Switch on Dry Iron . 3. Turn Temperature Control Dial to OFF ( O ). Unplug iron and hold over a sink with soleplate facing down. 4. Turn Adjustable Steam Switch to MAX, while pressing Blast of Steam button often. Boiling water and steam will flow out of steam vents. Allow all water to drain from iron. 5. Gently move iron front to back to allow water to clean entire soleplate area. 6. If water still remains inside of soleplate, reheat iron as indicated in Step 2. Boiling water and steam could still flow out of steam vents. 5