Harman Kardon AVR 1710S Owners Manual - Page 20

AVR Making Connections Connect IR Equipment The AVR is equipped with a Remote IR Input connector that lets you remotely control the AVR in a variety of situations: • When you place the AVR inside a cabinet or facing away from the listener, connect an external IR receiver, such as the optional Harman Kardon HE 1000, to the AVR's IR In jack. External IR Receiver AVR IR In Jack Connect the Trigger Output If your system has equipment that can be controlled by a DC trigger signal, connect it to the AVR's Trigger Out connector with a mono 1/8-inch (3.5mm) mini-plug interconnect cable. The AVR will supply a 12V DC (100mA) trigger signal at this connection whenever it is powered on. AVR AVR and Source Devices Installed Inside of Cabinet Mono 1/8-inch (3.5mm) Mini-Plug Interconnect (not supplied) Device with Trigger In Connector • If you install a multizone system (AVR 1710S/AVR 171S only), connect an IR control device to the Zone 2 IR In connector for remote-room control of the multizone system, source devices and volume in the remote zone. External IR Receiver Zone 2 Speakers Connect to AC Power AVR 171S/AVR 161S: Connect the supplied AC power cord to the AVR's AC Input connector and then to a working, non-switched AC power outlet. AVR AC Input Connector AC Power Outlet Zone 2 Main Room Power Cord (supplied) AVR 1710S/AVR 1610S: Connect the AVR's power cord to a working, non-switched AC power outlet. AVR Power Cord AC Power Outlet AVR If a source device is shared with the main listening area, any control commands issued to that source will also affect the main room. 20