Harman Kardon AVR 330 Owners Manual - Page 38
Resetting the Remote Memory
View all Harman Kardon AVR 330 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
PROGRAMMING THE REMOTE Example: To use the TV button to operate a second VCR, first press the TV Input Selector e and the Mute Button 42 at the same time until the red light glows under the TV Button e. Press the VCR Button e, followed by the three-digit code for the specific model you wish to control. Finally, press the TV Button e again. Resetting the Remote Memory As you add components to your home theater system, occasionally you may wish to totally reprogram the remote control without the confusion of any commands, macros or "Punch-Through" programming that you may have done. To do this, it is possible to reset the remote to the original factory defaults and command codes by following these steps. However, once the remote is reset, all commands or codes that you have entered will be erased and will need to be reentered: 1. Press any of the Input Selector Buttons e and the "O" Button r at the same time until the Program/SPL Indicator c begins to flash amber. 2. Press the "3" Button r three times. 3. The red LED under the Input Selector e will go out and the Program/SPL Indicator c will stop flashing and turn green. 4. The Program/SPL Indicator c will remain green until the remote is reset. Note that this may take a while, depending on how many commands are in the memory that need to be erased. 5. When the Program/SPL Indicator c goes out, the remote has been reset to the factory settings. 38 PROGRAMMING THE REMOTE