Harman Kardon FESTIVAL 500 Owners Manual - Page 12
Front, Panel, Controls, Electronic, Labels
View all Harman Kardon FESTIVAL 500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
12 FRONT PANEL CONTROLS AND ELECTRONIC LABELS CD and Tape Drawers The button to the right of the drawer on the CD and tape players can be pushed to open and close the drawer when inserting discs and tapes. The "EXTERNAL" indicator reminds you to check your external components, if any, anytime the auxiliary input/output jacks are in circuit. If "EXTERNAL" is lighted, but there is no sound, make sure your external device(s) are on. Here is the large four letter operating mode display, which shows at a glance which source is playing or if you're in CD favorite track programming mode (CDPR) (CD program). The main numeric display shows the CD track or radio station you're listening to, or the tape counter time. Except for the open/close buttons, all front panel controls are located on the tuner-controller within a large oval window. All system functions are accessed through pushbuttons located across the middle of this window. Additional set-and-forget controls are located behind a pull-down gate located immediately below the row of pushbuttons. NOTE: The speaker switch(es) behind door must be pushed in to hear music. "RECORD" indicates that a recording is currently in process. "MUTE" is displayed anytime the PAUSE control is engaged. ip TI IAv REEXCTEORRNDAMUTE.' TRACK PRESET 2 TRACK TIME I I /•: : I1T V / I Power Pause ®Speak®er Push The Dolby® noise reduction indicator comes on to show the type of noise reduction being applied to the tape. a0 Do BC •ainri ." - Volume r ) The tape direction indicators show the actttal direction of tape movement. Note: The speaker switch(es) behind door must be pushed in to hear music. The functions of these four buttons are identified by these four ELECTRONIC LABELS directly above them, allowing the functions to change. To activate Electronic Labels, simply press any of these four buttons. Then proceed by pressing the button directly below the feature label you wish to use. If at any time you to wish start over, simply wait 10 sec. and start again.