Harman Kardon Go Play Wireless Owners Manual - Page 4

HARMAN KARDON GO + PLAY WIRELESS Bluetooth Pairing and Technical Specifications Listening to Audio from a Bluetooth-Capable Device Technical Specifications 1. Press the Harman Kardon Go + Play Wireless's "Power" button. The Status LED will illuminate white. 2. The Harman Kardon Go + Play Wireless unit will automatically enter the Bluetooth pairing mode. 3. Perform a new device search on your Bluetooth-capable device. 4. Select "GO+PLAY WIRELESS" on the device's pairing list. If the device asks for a passcode, enter 0000. 5. When pairing is successful the Harman Kardon Go + Play Wireless's Status LED will change to blue. 6. Control playback from your Bluetooth-capable device. To pair with a different device, press and hold the Power button until the LED turns white, then repeat steps 3 - 5 above. Model: Optional batteries for unit: Drivers: Power: Frequency response: Input sensitivity (Aux In): Bluetooth transmitter frequency range: Harman Kardon Go + Play™ Wireless 8 type D alkaline batteries Two Ridge and two Atlas transducers Tweeters: 2 x 15 watts @ 1% THD Woofers: 2 x 30 watts @ 1% THD 40Hz - 20kHz 250mV 2.4GHz - 2.4835GHz Listening to Music from an Auxiliary Device 1. Connect the auxiliary device's output into the "Aux in" jack by using a stereo 3.5mm (1/8" auxiliary cable (not supplied). 2. Press the "Power" button located on top of the Harman Kardon Go + Play Wireless system to turn on the unit. 3. Control music playback through the auxiliary device. 4. Adjust volume using the Volume Up ("+") and Volume Down ("-") buttons located on top of the unit. Bluetooth transmitter power: Bluetooth transmitter modulation: Dimensions: Weight: Input impedance: ≤20dBm (EIRP) GFSK/ /4-DQPSK/8-DPSK Length: 20" (500mm) Width: 9" (230mm) Height: 9-1/2" (240mm) 9.4 lb (4.3kg) >10k ohms Charging Your iPhone/iPod Signal-to-noise ratio: External power supply >85dB Input voltage: 100 - 240V AC 1. Use the cable that came with your iPad, iPhone or iPod to connect it to the rear USB port Output voltage: 18VDC @ 3.6A of the Go+Play Wireless. (The rubber landing area on top of your Go+Play Wireless is the perfect place for resting your iPhone or iPod while charging.) Power consumption: 65W (maximum); 0.5W (standby mode) 2. Make sure that the Harman Kardon Go + Play Wireless unit is connected to a live electrical HARMAN International hereby declares that this equipment is in compliance with the essential requirements outlet. Note: The Harman Kardon Go + Play Wireless system will not charge other devices. 3. The Harman Kardon Go + Play Wireless unit will not charge an iPhone/iPod device while running on battery power. and other relevant provisions of Directive 1999/5/EC, ErP 2009/125/EC Directive and RoHS 2011/65/EU Directive. The declaration of conformity may be consulted in the support section of our Web site, accessible from www.harmankardon.com 4