Harman Kardon HK6100 Owners Manual - Page 7
Troubleshooting, Checklist
View all Harman Kardon HK6100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
TROUBLESHOOTING CHECKLIST Most of the problems consumers have with their high fidelity system are due to incorrect operation. If this unit does not operate as you intended, first check the items in the following checklist. Also check other related components such as the tuner, turntable, speakers and other electrical equipment you use with this amplifier. Problem Cause Remedy The POWER indicator does not light up when the POWERswitch is pressed. • The power cord is not plugged in. • Plug in the power cord securely. The POWER indicatorlights up, but no sound is heard. • The TAPE MONITOR selector is in the Tape 1 or Tape 2 position. • The FUNCTION selection was not made properly. • The SPEAKERS selector is in the Off position. • The speaker wires are disconnected or broken. • Set the TAPE MONITOR selector to theSource position. • Set the FUNCTION selector to the proper position for the desired program source. • Set the SPEAKERS selector to the position of your desired speaker system(s). • Check the speaker wires and connect them correctly. Sound is not heard from the speaker system on one side. • The connection of speaker wires is incorrect or incomplete. • The connection wires to other equipment are disconnected. • The BALANCE control knob is turned to either the extreme right or left position. • Check the speaker wires for disconnection or breaking and reconnect them correctly. • Check the wires for disconnection and connect them correctly. • Set the mark on the BALANCE control knob to the center position. When listening to stereo sound, the left and right sounds are reversed. • The left and right speaker wires are reversed. • The left and right wires connected to other equipment are reversed. • Check the speaker wires and connect them correctly. • Check the wires to other equipment and connect them correctly. When playing a turntable, a low-pitched noise ("hum" or "buzz") is heard. • The ground wire of the turntable is disconnected. • The connections of the turntable wires are incorrect or incomplete. • Make the ground wire connection correct ly. • Insert the turntable wires into the PHONO jacks of this unit securely. When increasing the volume level while playing a turntable, an undesirable prolonged sound (howling) is heard. • "Howling" is created by the speakers and turntable. • Too much low frequency sound is present. • Place the speakers further away from the turntable. • Place the turntable on a more solid surface. • Decrease the setting of the BASS control knob. • Turn off the Loudness switch. Sound quality is poor. • Input components have not been set up correctly. • Tone control is not proper. • Check the antenna of the tuner, cartridge of the turntable, or head of the tape deck, etc. and make corrections as needed. • Adjust the BASS and/or TREBLE control knobs to obtain the desired tone, NOTE FOR CANADIAN CUSTOMERS AC Convenience Receptacles This unit is provided with two AC convenience receptacles on the rear panel for supplying power to a tuner, turntable, tape deck or other low power component. The receptacles have a power capacity of 180 watts each. Check the component's owner's manual to find its power requirement. SWITCHED: The power to this receptacle is turned on and off by this unit's power switch. UNSWITCHED: The power to this receptacle is independent of this unit's power switch. 6