Harman Kardon HKTS 15 Owners Manual - Page 8
Mounting Options - speaker system
View all Harman Kardon HKTS 15 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
MOUNTING OPTIONS Satellites and Surrounds Wall-Mounting Unscrew the bolt that attaches the black shelf stand to the bottom of the speaker. Store the stand and bolt in a safe place in case they are needed for a future installation. The satellite speakers may be placed on a shelf. Place each satellite speaker on one of the supplied coasters for added stability and to protect your furniture. Wires to Speaker Terminal Cover They may be wallmounted using the supplied brackets. Wall Plate Wall Plate Mount the wallbracket attachment Remove Stand plate on the wall in the desired location. 15mm or 1/2" If possible, position the speakers so that the mounting screws (not included; use size #8) may be installed directly into a wooden wall stud. If that is not possible, use optional wall anchors that are rated to support at least twenty-five pounds. The customer is responsible for proper selection and use of mounting hardware, available through hardware stores, to properly and safely wall-mount the speakers. Referring to the speaker connection instructions on pages 9 through 12, thread the appropriate speaker cable through the opening in the bottom of the wall plate, and then through the back of the bracket, as shown in the diagram. The bracket has two openings Overhead View Wire From Wall Plate on top: a round screw hole, and an arcshaped opening in front of it. The speaker cable should be threaded through the arcshaped opening, not the screw hole. Attach the bracket to the wall plate by inserting the tab at the top of the wall plate into the slot on top of the bracket and snapping the bracket onto the wall plate. Thread the cable through the round opening in the terminal cover, and then insert the speaker wires into the terminals on the underside of the speaker, remembering to observe the correct polarity (see page 9). Place the terminal cover over the opening on the underside of the speaker so that it fits flush against the speaker and covers the terminals, with its round opening exposing the threaded insert. The bracket fits through the round opening in the terminal cover. Insert the supplied bracket bolt up through the bottom of the bracket and terminal cover, and screw it into the threaded insert on the underside of the speaker. The bolt should be snug, but not so tight as to prevent the bracket from pivoting. The wall-mounted speaker may be pivoted from side to side; however, the bracket is not designed to tilt up or down, and attempting to tilt it will damage the bracket and possibly the wall, which would not be covered by your warranty. Wall 23mm or 3/4" (M6-1.25P or 1/4"-20) 8 MOUNTING OPTIONS