Harman Kardon HKTS 18 Owners Manual - Page 8
Mounting Options - rating
View all Harman Kardon HKTS 18 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
MOUNTING OPTIONS Wall 23mm or 3/4" Satellites and Surrounds The satellite speakers may be placed on a sheRSlfte.amPnoldavcee each satellite speaker on one of the supplied 15mcmoasters for added stability and to or 1/2" protect your furniture. 23mm or 3/4" (M6-1.25P or 1/4"-20) The satellite speakers may be wall-mounted using the supplied brackets. Wall-Mounting Wall Plate 15mm Unscrew the bolt that attaches theorb1l/a2c"k shelf stand to the bottom of the speaker. Store the stand and bolt in a safe place, in case they are needed for a future installation. Remove Stand Wires to Speaker Terminal Cover Wires to Speaker 23mm or 3/4" Wall (M6-1.25P or 1/4"-20) Wall Plate Terminal Cover Wall Plate Mount the wall- Remove Stand Overhead View Wire Wall From Wall Plate bracket attachment plate on the wall in 15mm or 1/2" the desired loca- tion. If possible, position the Overhead View speakers so that the mounting screws (not included; use size #8) may be installed directly into a wooden wall stud. Wires to Speaker If that is not possible, use optional wall openings on top: a round screw hole, and an arc-shaped ope2Wn3minirmge in front of it. The speaker cable should boeFrr3ot/hm4r"eaded through the arc- Wall (M6-1.25P shaped openinPgl,anteot the scroerw1/4h"-o2l0e). Attach the bracket to the wall plate by inserting the tab at the top of the wall plate into the slot on top of the bracket and snapping the bracket onto the wall plate. anchors that arWe aralltePdlatotesupport at least Thread the cable through the round opening 25 poundRStesam.nodTvhee customer is responsTiberlemifnoarl Coverin the terminal cover, and then insert the proper selection and use of mounting hard- speaker wires into the terminals on the 15mm or 1/2" ware, available through hardware stores, to underside of the speaker, remembering to properly and safely wall-mount the speakers. observe the correct polarity (see page 9). Referring to the speaker connection instructions on pages 9 through 12, thread the appropriate speaker cable through the opening in the bottom of the wall plate, and then Wires to Speaker Overhead through the bacVkieowf the bracket, as shown in the diagram above. The bracket has two Place the terminal cover over the opening on the underside of the speaker so that it fits flush Wire against the speakerWaalnl dPlacteovers the tFerormminals, with its round opening exposing tW Phlaaetlelthreaded insert. The bracket fits through the round opening in the terminal cover. Terminal Cover Insert the supplied bracket bolt up through the bottom of the bracket and terminal cover, and screw it into the threaded insert on the underside of the speaker. The bolt should be snug, but not so tight as to prevent the bracket from pivoting. The wall-mounted speaker may be pivoted from side to side; however, the bracket is not designed to be tilted up or down, and attempting to tilt it will damage the bracket and possibly the wall, which would not be covered by your warranty. Wall Plate Wall 23mm or 3/4" (M6-1.25P or 1/4"-20) 8 MOUNTING OPTIONS