Hayward ColorLogic 2.5 Model: Series SP0521

Hayward ColorLogic 2.5 Manual

Hayward ColorLogic 2.5 manual content summary:

  • Hayward ColorLogic 2.5 | Model: Series SP0521 - Page 1
    Underwater ColorLogie LED Lighting Fixtures FOR SWIMMING POOLS OWNER'S GUIDE INSTALLATION AND OPERATING INSTRUCTIONS UL Listed File No. E234517 0 GENERAL INFORMATION MODEL # VOLTAGE WATTAGE WIRE SIZE The Hayward ColorLogic LED (light-emitting diode) underwater lighting fixture you have
  • Hayward ColorLogic 2.5 | Model: Series SP0521 - Page 2
    Hayward PVC Fixture Housings (Niches), see installation instructions provided with the fixture housing. INSTALL FIXTURE HOUSING (NICHE) The light fixture must be installed in or on a wall of the pool supply, switch panel, pool/spa controller, etc. Snake raised to the pool deck for servicing. Cut off
  • Hayward ColorLogic 2.5 | Model: Series SP0521 - Page 3
    Hayward ColorLogic lights are controlled via power-cycling. No special controller is required to activate the light and switch it through different modes. The light fixture can be switched with any basic on/off light switch. If a Hayward PSC2100 Pool/Spa Control System is being used, wire the LED
  • Hayward ColorLogic 2.5 | Model: Series SP0521 - Page 4
    . Show - Mardi Gras - Fast Random Fade 12. Show - Cool Cabaret - Slow Random Fade TROUBLESHOOTING If you have a problem with your Hayward ColorLogic light, please try the following tips before calling for service: PROBLEM: Light will not advance to the next show when it is power-cycled. SOLUTION: Do
  • Hayward ColorLogic 2.5 | Model: Series SP0521 - Page 5
    8.87 in 22.53 cm PRODUCT ILLUSTRATIONS CO • HAYWARD 12.75 in 32.36 cm Col orLogic 3.00 in 1" X 3/4" ADAPTOR (OPTIONAL) • * FIXTURE HOUSING ILLUSTRATED IS MODEL SP-600 FOR CONCRETE/GUNITE POOLS. FOR VINYL, FIBERGLASS, OR STEEL, SEE DATA SHEET PACKED WITH FIXTURE HOUSING. FIXTURE HOUSING (NICHE)*
  • Hayward ColorLogic 2.5 | Model: Series SP0521 - Page 6
    . 620 Division Street Elizabeth, NJ 07207, USA Tel: 908 351 5400 Fax: 908 351 5675 Hayward Pool Products, Inc. 2875 Pomona Boulevard Pomona, CA 91768, USA Tel: 909 594 1600 Fax: 909 598 6905 Hayward Pool Products Canada, Inc. 2880 Plymouth Drive Oakville, Ontario, CANADA, L6H 5R4 Tel: 905 829 2880
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6

HAYWARD
Underwater
ColorLogie
LED
Lighting
Fixtures
FOR
SWIMMING
POOLS
OWNER'S
GUIDE
INSTALLATION
AND
OPERATING
INSTRUCTIONS
GENERAL
INFORMATION
0
UL
Listed
File
No.
E234517
The
Hayward
ColorLogic
LED
(light
-emitting
diode)
underwater
lighting
fixture
you
have
purchased
is
designed
to
mount
into
Hayward
DuraNiche
Series
models
SP600
and
SP607
manufactured
1993
and
later.
Hayward
light
fixtures
may
fit
into
other
niches,
but
the
installation
will
not
carry
a
U.L.
approval.
MODEL
#
VOLTAGE
WATTAGE
WIRE
SIZE
SP-0521LED30
SP-0521LED50
SP-0521LED100
120VAC
50W
#14
AWG
Hayward
SP520
Series
ColorLogic
LED
lights
are
U.L.
listed
under
file
number
E234517
and,
to
be
approved,
must
be
used
with
Hayward
models
SP600
or
SP607
fixture
housings
(niches).
Installation
of
light
and
niche
must
be
in
accordance
with
Article
680
of
the
National
Electric
Code
(N.E.C.)
and
any
applicable
local
codes.
If
non-metallic
conduit
is
used,
a
#8
AWG
grounding
conductor
must
be
run
through
the
conduit
and
connected
to
the
grounding
connector
on
the
inside
of
the
niche.
This
connection
must
be
encapsulated
using
a
listed
potting
compound
in
accordance
with N.E.C.
Article
680-20,
such
as
3M
Inc.
Scotch
Cast
Wet
Niche
Potting
Compound
No.
2135
(U.L.
File
E130394)
or
equivalent.
The
integral
external
connection
on
the
niche
is
for
the
#8
AWG
bonding
conductor
also
required
by
the
N.E.C.
Please
refer
to
your
niche
installation
instructions
for
details.
Except
when
the
fixture
is
installed
in
an
area
of
the
swimming
pool
that
is
not
used
for
swimming
and
the
lens
is
adequately
guarded
to
keep
any
person
from
contacting
it,
the
fixture
must
be
installed
in
or
on
a
wall
of
the
pool,
with
the
top
of
the
lens
not
less
than
4
inches (10.2
cm)
below
the
normal
water
level
of
the
pool.
Important
Note
When
Installing
SP
-600
Niche
(for
ConcretelGunite
Pools):
A
cover
and
two
screws
have
been
provided
to
protect
the
niche
and
mounting
screw
holes.
Leave
these
in
place
during
construction
to
prevent
intrusion
of
concrete
which
may
foul
the
niche
or
threads.
REMOVE
and
discard
both
the
screws
and
the
protective
cover
when
ready
to
install
the
light
fixture.
IMPORTANT
SAFETY
INSTRUCTIONS
READ
AND
FOLLOW
ALL
INSTRUCTIONS
When
installing
and
using
this
electrical
equipment,
basic
safety
precautions
should
always
be
followed,
including
the
following:
Failure
to
follow
instructions
may
result
in
injury.
1.
Warning
-
Risk
of
Electric
Shock.
Do
not
open.
Pool
light
has
no
user
serviceable
parts
inside.
2.
Warning
-
To
reduce
the
risk
of
injury,
do
not
permit
children
to
use
this
product
unless
they
are
closely
supervised
at
all
times.
3.
Caution
-
This
swimming
pool
light
is
U.L.
Listed
for
permanently
installed
pools
only.
It
is
not
listed
for
storable
pools.
Permanently
installed
pools
are
those
constructed
in
or
partially
in
the
ground
and
all
others
capable
of
holding
water
in
a
depth
greater
than
42
in
(1.07
m).
Storable
pools
are
those
constructed
on
or
above
the
ground
and
capable
of
holding
water
to
a
maximum
depth
of
42
in
(1.07
m).
4.
This
Light
Fixture
must
be
installed
by
qualified
personnel
in
compliance
with
the
National
Electric
Code
(N.E.C.)
and
any
applicable
local
codes.
5.
Disconnect
electrical
power
before
installing
or
servicing
this
equipment.
6.
Improper
installation
may
result
in
death
or
serious
injury
to
bathers
or
service
personnel
or
others
by
way
of
electric
shock.
Read
and
follow
all
instructions.
SAVE
THESE
INSTRUCTIONS
CAUTION:
Local
electrical
codes
and/or
regulations
must
be
followed
when
installing
this
light
fixture.