Hayward HeatPro Heat Pro Owners Operations & Parts Manual

Hayward HeatPro Manual

Hayward HeatPro manual content summary:

  • Hayward HeatPro | Heat Pro Owners Operations & Parts Manual - Page 1
    Rev: D Models: HP20654T, HP20654BT, HP20854T, HP20854BT and HP21104T OWNERS OPERATION & PARTS MANUAL Attention Installer: Give this manual to the homeowner. Important Information to keep for Service Model Serial Install Date SAVE THIS OWNERS MANUAL The Hayward HeatPro Heat Pump is listed by
  • Hayward HeatPro | Heat Pro Owners Operations & Parts Manual - Page 2
    Page 2 of 22 HEATPRO HEAT PUMP HP13023772 Rev: D IMPORTANT SAFETY INSTRUCTIONS READ AND FOLLOW ALL INSTRUCTIONS IN THIS OWNER'S MANUAL AND ON EQUIPMENT. Before servicing this electrical equipment, turn power supply OFF. KEEP ALL LABELS IN GOOD CONDITION AND REPLACE IF MISSING OR DAMAGED.
  • Hayward HeatPro | Heat Pro Owners Operations & Parts Manual - Page 3
    safety and operation instructions could result in violent separation of the pump housing and cover due to pressure in the system, which could cause property damage, severe personal injury, or death. Before servicing pool and spa water circulation system, all system and pump controls must be in
  • Hayward HeatPro | Heat Pro Owners Operations & Parts Manual - Page 4
    abbreviation for pounds per square inch. General Information: Swimming Pool Energy Saving Tips It is important to note that a heat pump will not heat a pool as fast as a gas heater. If the pool water is allowed to cool significantly, it may take a heat pump several days to return pool water to the
  • Hayward HeatPro | Heat Pro Owners Operations & Parts Manual - Page 5
    temperature control of pool and spa o Display of self diagnostic codes to monitor heat pump performance; o Control Lock Out Function; o Defrost Function to prevent evaporator coil freeze up; - Titanium Heat Exchanger withstands the harshest conditions. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
  • Hayward HeatPro | Heat Pro Owners Operations & Parts Manual - Page 6
    with Your Heat Pump Heat Pump Protection Features Hayward heat pumps are equipped with safeguards that will stop operation to protect the unit in case of the following events: • Excessively high refrigerant pressure • Excessively high water temperature • Loss of refrigerant • Fan Motor Failure
  • Hayward HeatPro | Heat Pro Owners Operations & Parts Manual - Page 7
    (display will show "dEF"). After the 2-hour period, the unit will restart to check the evaporator temperature and try to resume normal operation. The heat pump control will continue this cycle until the evaporator temperature returns to normal. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Pomona
  • Hayward HeatPro | Heat Pro Owners Operations & Parts Manual - Page 8
    this range during operation or if water continues to drain from the base when the heat pump is not in operation for more than an hour, a leak in the internal plumbing may have occurred. The troubleshooting section provides recommendations if leaks are suspected. NOTICE: Keep the drain hole clear of
  • Hayward HeatPro | Heat Pro Owners Operations & Parts Manual - Page 9
    Page 9 of 22 HEATPRO HEAT PUMP HP13023772 Rev: D NOTICE Make sure there are no sprinkler heads near the heat pump that will spray on or into the unit. Sprinkler damage is not covered under the warranty agreement. Make sure that sprinklers are placed at a sufficient distance away, so that normal
  • Hayward HeatPro | Heat Pro Owners Operations & Parts Manual - Page 10
    the installer. NOTE: Damage caused by flow rates outside this range will void the warranty. CAUTION - Keep all objects off the top of the heat pump. Blocking airflow could damage the unit and will void the warranty. Start-Up Procedures 1. Apply power to the pool heater by plugging in the non-fused
  • Hayward HeatPro | Heat Pro Owners Operations & Parts Manual - Page 11
    Page 11 of 22 HEATPRO HEAT PUMP Becoming Familiar with HeatPro Heat Pump Controls Display Window HP13023772 Rev: D Up Arrow Button Down Arrow Button Spa Button (Optional) Run Light Heat Pump Control Panel Pool Button Display Window (All Models) Up Arrow Button (All Models) Down Arrow Button
  • Hayward HeatPro | Heat Pro Owners Operations & Parts Manual - Page 12
    Operation HEATPRO HEAT PUMP HP13023772 Rev: D Dual Thermostat (Models HP20654T, HP20654BT, HP20854T, HP20854BT & HP21104T) On/Off: To enter Standby mode: To exit Standby mode: This control does not have a true on/off feature. The unit uses standby mode instead. Scrolling dots in the display
  • Hayward HeatPro | Heat Pro Owners Operations & Parts Manual - Page 13
    Page 13 of 22 HEATPRO HEAT PUMP Changing Temperature Display (All Models): HP13023772 Rev: D The control will display temperatures in either degrees Fahrenheit or Celsius. To change the temperature display, place the heat pump in "Stand-By" mode so that the scrolling dots appear on the screen.
  • Hayward HeatPro | Heat Pro Owners Operations & Parts Manual - Page 14
    you can place the heat pump in standby mode. End of Season (Winterizing) Failure to properly winterize heat pump may result in serious equipment damage. Freeze damage is NOT covered under the heat pump warranty. Many pool service companies offer "Winterizing" assistance. Hayward recommends using
  • Hayward HeatPro | Heat Pro Owners Operations & Parts Manual - Page 15
    through the heat pump. Loss of water through loose plumbing connections may result in damage to circulating pump, pool / spa structure and / or other equipment. Performance Maintenance and Troubleshooting Service Procedures Before Calling For Service If there appears to be a problem, refer to
  • Hayward HeatPro | Heat Pro Owners Operations & Parts Manual - Page 16
    the unit is functioning. If the two temperatures are the same, there may be a problem. Note: Use a solar blanket / cover on the surface of the pool in order to minimize heat loss. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Pomona, CA Clemmons, NC Nashville, TN Tel: 908.351.5400 www.haywardpool.com
  • Hayward HeatPro | Heat Pro Owners Operations & Parts Manual - Page 17
    . NOTICE: Service to be conducted ONLY by an EPA Certified Service Technician. General Troubleshooting Guide for Hayward HeatPro Heat Pump Problem Unit is not refer to Operating section) Fan not functioning Call Pool Service Provider. Heat pump is running but is not heating "Run" light does
  • Hayward HeatPro | Heat Pro Owners Operations & Parts Manual - Page 18
    Page 18 of 22 HEATPRO HEAT PUMP HP13023772 Rev: D Display Diagnostic Codes - Troubleshooting Guide for Hayward HeatPro Heat Pump Display Problem Possible Cause Solution (Blank) No power to heat pump Unit will not turn on PS Water Pressure Switch LP Low Pressure Switch Tripped circuit
  • Hayward HeatPro | Heat Pro Owners Operations & Parts Manual - Page 19
    Page 19 of 22 HEATPRO HEAT PUMP Heat Pump Replacement Parts Diagram CONTROL BOX FOR: HP2654T, HP20654BT, HP2854T, HP20854BT & HP21104T HP13023772 Rev: D USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Pomona, CA Clemmons, NC Nashville, TN Tel: 908.351.5400 www.haywardpool.com
  • Hayward HeatPro | Heat Pro Owners Operations & Parts Manual - Page 20
    Page 20 of 22 HEATPRO HEAT PUMP Heat Pump Replacement Parts List HP13023772 Rev: D Item Part description 1 FAN TOP 2 SIDE PANEL 3 CONTROL BOX COVER 4 CONTROL BOX 5 CONTACTOR 6 CONTROL BOARD ASSY 7 INTERFACE BOARD 8 WATER PRESSURE SWITCH 9 TRANSFORMER 10 CAPACITOR 11 BENT COIL with
  • Hayward HeatPro | Heat Pro Owners Operations & Parts Manual - Page 21
    and services performed under terms of this warranty must be approved by HAYWARD. All parts returned under terms of this warranty will be repaired or replaced and returned transportation charges prepaid, by best and most economical means. INTERNATIONAL WARRANTY The HAYWARD heat pump pool heater is
  • Hayward HeatPro | Heat Pro Owners Operations & Parts Manual - Page 22
    Page 22 of 22 HEATPRO HEAT PUMP HP13023772 Rev: D ▼DETACH HERE: Fill out bottom portion completely and mail within 10 days of purchase/installation. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Pomona, CA Clemmons, NC Nashville, TN Tel: 908.351.5400 www.haywardpool.com
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22

HP13023772 Rev: D
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Pomona, CA
Clemmons, NC
Nashville, TN
Tel: 908.351.5400
www.haywardpool.com
Models: HP20654T, HP20654BT, HP20854T,
HP20854BT and HP21104T
OWNERS OPERATION & PARTS MANUAL
Basic safety precautions should always be followed, including the following: Failure to follow instructions can cause severe
injury and/or death.
This is the safety-alert symbol. When you see this symbol on your equipment or in this manual, look for one of the
following signal words and be alert to the potential for personal injury.
WARNING
warns about hazards that
could
cause serious personal injury, death or major property damage and if
ignored presents a potential hazard.
CAUTION
warns about hazards that
will
or
can
cause minor or moderate personal injury and/or property damage
and if ignored presents a potential hazard.
It can also make consumers aware of actions that are unpredictable and unsafe.
The
NOTICE
label indicates special instructions that are important but not related to hazards.
The Hayward HeatPro Heat Pump is listed by ETL as complying with the latest edition of the “UL Standard for Safety for
Heating and Cooling Equipment”, UL1995 and CSA C22.2 No. 236.
All Hayward HeatPro Heat Pumps must be installed in accordance with all applicable National and Local codes. In the absence
of local codes, refer to the latest edition of the National Electric Code (NEC) in the United States and the Canadian Electric
Code (CEC) in Canada
Important Information to
keep for Service
Model # ___________________
Serial # ____________________
Install Date ________________
SAVE THIS OWNERS MANUAL
Attention
Installer:
Give this manual to
the homeowner.