Hayward Saline C 6.0 Saline C 6.0 Owner's Manual

Hayward Saline C 6.0 Manual

Get Hayward Saline C 6.0 PDF manuals and user guides View all Hayward Saline C 6.0 manuals
Add to My Manuals
Save this manual to your list of manuals

Hayward Saline C 6.0 manual content summary:

  • Hayward Saline C 6.0 | Saline C 6.0 Owner's Manual - Page 1
    RevE Saline CTM 6.0 Commercial Salt Chlorine Generator Owner's Manual Contents Description 3 Installation 4 Operation 7 Maintenance 8 Parts Guide 9 Warranty 11 INTERTEK CC M C US LISTED 3101970 Conforms to UL 1081 and CSA, C22.2 #218.1 HCSC60 IMPORTANT SAFETY INSTRUCTIONS Basic
  • Hayward Saline C 6.0 | Saline C 6.0 Owner's Manual - Page 2
    to ensure that the Saline C 6.0 system manual air relief valve until a steady stream of water (not air or air and water) is discharged. Notice: This product should be installed and serviced only by a qualified pool professional. SAVE THESE INSTRUCTIONS USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
  • Hayward Saline C 6.0 | Saline C 6.0 Owner's Manual - Page 3
    C 6.0 is certified to produce 5 pounds of equivalent chlorine per day (based on 3500 ppm of salt). The system produces chlorine continuously from a salt concentration of 3500 ppm to 5000 ppm added to the pool. The Saline C 6.0 is designed for commercial service and can be operated 24 hours a day and
  • Hayward Saline C 6.0 | Saline C 6.0 Owner's Manual - Page 4
    to make the installation as problem free as possible. The support the weight of the power supply using only drywall anchors. The power supply must have a stud for support Saline C 6.0 is disconnected and the system is unable to operate. Blue Control Cord 4 USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
  • Hayward Saline C 6.0 | Saline C 6.0 Owner's Manual - Page 5
    The System Saline C 6.0 systems require a minimum of 40 gpm of flow through the electrolytic cell housing to achieve the rated production of chlorine. The system See the plumbing diagrams below. SALINE C 6.0 System Plumbing Bypass Manifold Plumbing 5 USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
  • Hayward Saline C 6.0 | Saline C 6.0 Owner's Manual - Page 6
    Cell Wiring Connect the cell to the power supply with the connector provided. C"eZll" COonuntelecttion "OUu" tlet Ou"Ztl"et FS"lwoUwitc" h COonuntelcettor 6 USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
  • Hayward Saline C 6.0 | Saline C 6.0 Owner's Manual - Page 7
    stop generating chlorine and the LCD display will flash "LO SALT". To reset, correct the salt concentration and hold the output selector in the down position. When the fault is cleared, reset the output to the desired level. LCD Display Output Selector 7 USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
  • Hayward Saline C 6.0 | Saline C 6.0 Owner's Manual - Page 8
    chlorine from the salt that you have added to the water. It will only continue to operate correctly if salt is maintained at a minimum 3500 ppm level. NOTICE: Low salt will lower the amount of chlorine plug for service. To drain following instructions: The Saline C HAYWARD GENUINE REPLACEMENT PARTS
  • Hayward Saline C 6.0 | Saline C 6.0 Owner's Manual - Page 9
    Winterization In some cold climates it may be necessary to winterize the Saline C6 system. The procedure for this is as follows: • Disconnect power to the system • Close lid. Make sure no water is in the vessel if there is a possibility of freezing. Parts Guide 9 USE ONLY HAYWARD GENUINE REPLACEMENT
  • Hayward Saline C 6.0 | Saline C 6.0 Owner's Manual - Page 10
    10 USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
  • Hayward Saline C 6.0 | Saline C 6.0 Owner's Manual - Page 11
    of this equipment, Hayward Industries, Inc. warrants its Salt Chlorine Generator HCSC60 to be improper use or care or any Acts of God. Parts that fail or become defective during the warranty period charge. Proof of purchase is required for warranty service. In the event proof of purchase is not
  • Hayward Saline C 6.0 | Saline C 6.0 Owner's Manual - Page 12
    AT www.haywardcommercialpool.com. FOR FURTHER INFORMATION OR CONSUMER TECHNICAL SUPPORT, VISIT OUR WEBSITE AT wwww.haywardcommercialpool.com Hayward is a registered trademark and Saline C is a trademark of Hayward Industries, Inc. © 2013 Hayward Industries, Inc. All other trademarks not owned by
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
ISHCSC60 RevE
Hayward Commercial Pool Products
10101 Molecular Drive, Suite 200
Rockville, MD 20850
Phone: (800) 657-2287
www.haywardcommercialpool.com
Owner’s Manual
HCSC60
Contents
Description
.....................
3
Installation
.....................
4
Operation
........................
7
Maintenance
...................
8
Parts Guide
.....................
9
Warranty
........................
11
Commercial Salt Chlorine Generator
Saline C
6.
0
TM
IMPORTANT SAFETY INSTRUCTIONS
Basic safety precautions should always be followed, including the following: Failure to follow instructions can
cause severe injury and/or death.
This is the safety-alert symbol. When you see this symbol on your equipment or in this manual, look for
one of the following signal words and be alert to the potential for personal injury.
WARNING
warns about hazards that could cause serious personal injury, death or major property dam-
age and if ignored presents a potential hazard.
CAUTION
warns about hazards that will or can cause minor or moderate personal injury and/or property
damage and if ignored presents a potential hazard.
It can also make consumers aware of actions that are
unpredictable and unsafe.
The
NOTICE
label indicates special instructions that are important but not related to hazards.
CM
L
I
S
T
E
D
I
N
T
E
R
T
E
K
US
C
3101970
Conforms to UL 1081 and
CSA, C22.2 #218.1