Hayward Saline C 6.0 Saline C 6.0 Owner's Manual - Page 4
Installation
View all Hayward Saline C 6.0 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
INSTALLATION Unpacking Units are shipped from the factory. In the event of damage during shipping, it is the responsibility of the customer to notify the carrier immediately and to file a damage claim. Open the crate or packaging carefully and examine all material inside. Storage When storing units, use the original packaging and store under a shelter to protect the contents from weather. Plan Ahead Almost every pump room encountered is different. It is imperative to have prior knowledge of the facility in which the unit is to be installed and to evaluate what type of tools, wall anchors, etc. will be needed to make the installation as problem free as possible. The power supply must be mounted within 5 feet of the cell housing so the DC cables to the top of the electrolytic cell will reach. Also, any pool controller must be within 5 feet of the power supply so the control cord will reach. Power Supply Installation The Saline C 6.0 system comes with 4 rubber feet on the bottom of the power supply and 4 keyhole mounting holes on the back of the power supply. The power supply can sit on a shelf or similar structure without any mounting or the system can be mounted on to a wall. CAUTION To reduce the risk of injury - Never try to support the weight of the power supply using only drywall anchors. The power supply must have a stud for support! Locate a space on the wall, in the pump room, that will accommodate the dimensions of the power supply. The two top keyhole mounting holes are 11-1/4 inches apart. Install screws and hang the power supply. System Wiring WARNING - Risk of Electric Shock. Hazardous voltage can shock, burn and cause death or serious property damage. To reduce the risk of electrical shock, turn off all power to the system. CAUTION Chemical Hazard - Chemicals can cause internal and external burns, causing death, serious injury or property damage, to avoid: all systems must be wired so that when the pool circulation pump is off, the power to the Saline C 6.0 is off. Consult a Certified Electrician for the best wiring method to achieve this. Power Cord Cell Cables All Saline C 6.0 systems ship from the factory with a 3 foot black power cord and a 6 foot blue control cord. Plug the power cord into a minimum 15 amp wall outlet protected by a ground fault circuit interrupter. Connect the blue control cord to a chemical feed controller or for continuous operation without the use of a chemical feed controller, plug the blue control cord into a 15 amp wall outlet protected by a ground fault circuit interrupter. This outlet must be interlocked with the circulation pump of the pool so that if the pump is turned off, power to the Saline C 6.0 is disconnected and the system is unable to operate. Blue Control Cord 4 USE ONLY HAYWARD GENUINE REPLACEMENT PARTS