Hayward SwimClear™ Models: C2025 C3025 C4025 C5025 C7000

Hayward SwimClear™ Manual

Hayward SwimClear™ manual content summary:

  • Hayward SwimClear™ | Models: C2025 C3025 C4025 C5025 C7000 - Page 1
    PARTS Models C2025 C3025 C4025 C5025 C7000 SWIMCLEAR™ CARTRIDGE FILTERS MODEL EFFECTIVE FILTRATION RATE DESIGN FLOW RATE Residential Commercial FT2 M2 GPM LPM C2025 225 20.9 84 318 C3025 325 30.2 122 462 C4025 425 39.5 150 568 C5025 525 48.8 150 568 C7000 680 63.2 150
  • Hayward SwimClear™ | Models: C2025 C3025 C4025 C5025 C7000 - Page 2
    reinforced seal. Non-Hayward components may fail in use and cause explosive separation. • Never rely on hand tightening the clamp nut to the clamp bolt. Using a ¾" socket on a torque wrench, torque clamp nut and clamp bolt to 150 inch-lbs. • Before starting system pump, insure filter manual air
  • Hayward SwimClear™ | Models: C2025 C3025 C4025 C5025 C7000 - Page 3
    Page 3 of 12 SWIMCLEAR CARTRIDGE FILTER ISC2028 REV C WARNING - SUCTION ENTRAPMENT HAZARD. Suction in suction outlets and/or suction outlet covers that are, damaged, broken, cracked, missing, or unsecured can cause severe injury and/or death due to the following entrapment hazards: Hair
  • Hayward SwimClear™ | Models: C2025 C3025 C4025 C5025 C7000 - Page 4
    IN CM C2025 32.5 83 18 46 15 38 C3025 34.5 88 18 46 16 41 C4025 40.5 103 18 46 18 46 C5025 46.5 118 18 46 22 56 C7000 52.5 133 18 46 28 71 INSTALLATION B WARNING This product should be installed and serviced only by a qualified pool professional. 1. The filter system
  • Hayward SwimClear™ | Models: C2025 C3025 C4025 C5025 C7000 - Page 5
    clamp nut to clamp bolt to 150 inch-lbs. Verify that the filter manual air relief body is in the LOCK position, and no filter components are missing, damaged or not genuine Hayward components. (See Fig 2) 2.Close filter drain. Note: Filter plug requires an o-ring seal. (See Fig 4) 3.Open all system
  • Hayward SwimClear™ | Models: C2025 C3025 C4025 C5025 C7000 - Page 6
    Page 6 of 12 SWIMCLEAR CARTRIDGE FILTER ISC2028 REV C MAINTAINING YOUR FILTER WARNING Figure 4 This product should be installed and serviced only by a qualified pool professional. FILTER DISASSEMBLY INSTRUCTIONS 1. Turn off all system circulation pumps and all electric power on the equipment
  • Hayward SwimClear™ | Models: C2025 C3025 C4025 C5025 C7000 - Page 7
    CLAMP WITH HAMMER OR METAL TOOLS. 5. Follow Operation Instructions for "Starting the Pump and Filter System" (Page 5). VACUUMING POOL Vacuuming can be performed directly into the filter whenever needed. Clean cartridges after vacuuming, if required. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
  • Hayward SwimClear™ | Models: C2025 C3025 C4025 C5025 C7000 - Page 8
    may help. This product should be installed and serviced only by a qualified pool professional. RE-INSTALLATION OF THE MANUAL AIR RELIEF VALVE 1. Check the o-ring seals, replace as needed. 2. With a clean cloth, wipe upper filter body and o-ring groove. Remove all dirt and debris. 3. Align the
  • Hayward SwimClear™ | Models: C2025 C3025 C4025 C5025 C7000 - Page 9
    Page 9 of 12 SWIMCLEAR CARTRIDGE FILTER ISC2028 REV C SERVICE AND REPAIRS Consult your local authorized Hayward dealer or service center. No returns may be made directly to the factory without the expressed written authorization of Hayward Pool Products. SUGGESTED POOL CHEMISTRY LEVELS pH 7.2
  • Hayward SwimClear™ | Models: C2025 C3025 C4025 C5025 C7000 - Page 10
    Cartridge Element C4025 4 Required Cartridge Element C4520 Series 4 Required Cartridge Element C5025 4 Required Cartridge Element C5520 Series 4 Required Cartridge Element C7000 Series 8 Required Mid plate Connector C7000 only Inlet Elbow Outlet Elbow O-Ring Bottom Collector Manifold Lower Filter
  • Hayward SwimClear™ | Models: C2025 C3025 C4025 C5025 C7000 - Page 11
    Page 11 of 12 SWIMCLEAR CARTRIDGE FILTER ISC2028 REV C HAYWARD® LIMITED WARRANTY To Buyer, as original purchaser of this equipment, Hayward Pool Products, 620 Division Street, Elizabeth, New Jersey, warrants its products free from defects in materials and workmanship for a period of ONE (1) year
  • Hayward SwimClear™ | Models: C2025 C3025 C4025 C5025 C7000 - Page 12
    Page 12 of 12 SWIMCLEAR CARTRIDGE FILTER ISC2028 REV C PRODUCT REGISTRATION (Retain For Your Records) DATE OF INSTALLATION INITIAL PRESSURE GAUGE READING (CLEAN FILTER PUMP MODEL HORSEPOWER FILTER MODEL SERIAL NUMBER ▲Retain this Warranty Certificate in a safe and convenient location
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12

ISC2028 Rev C
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
INSTALLATION, OPERATION, & PARTS
Models
C2025
C3025
C4025
C5025
C7000
SWIMCLEARâ„¢ CARTRIDGE FILTERS
MODEL
EFFECTIVE FILTRATION
RATE
DESIGN FLOW RATE
Residential
Commercial
FT
2
M
2
GPM
LPM
C2025
225
20.9
84
318
C3025
325
30.2
122
462
C4025
425
39.5
150
568
C5025
525
48.8
150
568
C7000
680
63.2
150
568
MAXIMUM WORKING PRESSURE FOR ALL MODELS
50 PSI (3.45 BAR)
ATTENTION INSTALLER: THIS MANUAL CONTAINS IMPORTANT INFORMATION
ON THE OPERATION, AND SAFE USE OF THIS EQUIPMENT.
THIS MANUAL IS INTENDED FOR THE END USER OF THIS PRODUCT