HealthRider H190t Treadmill English Manual - Page 10
If You Do Not Connect The Con
View all HealthRider H190t Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
7. With the help of a second person, hold the console assembly near the Left Upright (88). Route the Upright Wire (77) around the indicated crossbar. Then, route the Upright Wire through the looped ties on the bottom of the console assembly. Connect the Upright Wire (77) to the console wire. See the inset drawing. The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF YOU DO NOT CONNECT THE CONNECTORS PROPERLY, THE CONSOLE MAY BECOME DAMAGED WHEN YOU TURN ON THE POWER. 7 Console Wire 77 Console Wire 77 Console Assembly Crossbar Ties 88 8. Set the console assembly on the brackets on the Left and Right Uprights (88, not shown). Be 8 careful not to pinch any wires. Attach the console assembly with four 5/16" x 1 1/4" Patch Screws (4) and four 5/16" Star Washers (11) (only one side is shown). Start all four Patch Screws, but do not tighten them 77 until assembly step 12 is completed. Insert the excess Upright Wire (77) into the hole in the console assembly. Tighten the ties around the Upright Wire and cut off the ends of the ties. Console Assembly Bracket Ties 11 4 88 10