HP 14-bs100 Maintenance and Service Guide - Page 58
M.2 solid-state drive adapter bracket, Remove the optical drive see
View all HP 14-bs100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
M.2 solid-state drive adapter bracket Three different SKUs related to storage are offered: ● Hard drive only ● M.2 solid-state drive only ● Hard drive and M.2 solid-state drive For hard drive only models, install the hard drive into hard drive bay. For solid-state drive only models, install the solid-state drive into the solid-state drive adapter bracket, and then into the hard drive bay. For hard drive and solid-state drive models, install the hard drive into the hard drive bay and install the solid-state drive into the separate solid-state drive connector on the system board. System boards are offered with an additional M.2 solid-state drive connector for hard drive and solid-state drive models. Description Solid-state drive adapter bracket Spare part number 925355-001 Before removing the solid-state drive adapter bracket, follow these steps: 1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system. 2. Disconnect all external devices connected to the computer. 3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then unplugging the AC adapter from the computer. 4. Remove the battery (see Battery on page 32). 5. Remove the optical drive (see Optical drive on page 34), if installed. 6. Remove the bottom cover (see Bottom cover on page 41). To remove the solid-state drive adapter bracket: 1. Remove the two Phillips PM2.0×3.0 screws (1) that secure the bracket to the computer. 2. Pull the bracket away from the connector (2). 3. Lift the bracket out of the computer (3) Reverse this procedure to reassemble and install the solid-state drive adapter bracket. 50 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts