HP 166207-B21 Configuring Arrays on HP Smart Array Controllers Reference Guide - Page 58
MSA1000 at dog sn: P56350D9IP903J, csn: 9J3CJN71XDCH, wwn
UPC - 720591292225
View all HP 166207-B21 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
show ssp If you use the config parameter, the output includes information about each device connected to the controller. When you use the ssp parameter, the output displays SSP information about the target controller. Example 1 => ctrl ch="lab4" show A typical output would be: MSA1000 at dog Bus Interface: Fibre WWN: 500805F3000BAC11 Serial Number: P56350D9IP903J Chassis Serial Number: 9J3CJN71XDCH Chassis Name: dog RAID 6 (ADG) Status: Enabled SSP State: Disabled Controller Status: OK Chassis Slot: 1 Hardware Revision: Rev A Firmware Version: 6.60 Rebuild Priority: Low Expand Priority: Low Surface Scan Delay: 20 sec Cache Board Present: True Cache Status: OK Accelerator Ratio: 100/0 (read/write) Read Cache Size: 128 MB Write Cache Size: 0 MB Total Cache Size: 128 MB Battery Pack Count: 1 Battery Status: OK Example 2 => ctrl all show Because this target consists of several devices, the output will be brief. A typical output would be: MSA1000 at dog (sn: P56350D9IP903J, csn: (9J3CJN71XDCH, wwn: 500805F3000BAC11) Smart Array 5312 in Slot 3 (sn: P4AB5X9BFMLNTJ) Smart Array 532 in Slot 2 (sn: P44940LDAORS4F) Example 3 => ctrl ch="lab4" show config The output in this case will have detailed information because the target consists of only one device. A typical output would be: MSA1000 at dog (sn: P56350D9IP903J, csn: (9J3CJN71XDCH, wwn: 500805F3000BAC11) array A (Parallel SCSI, Unused Space: 20091 MB) logicaldrive 1 (219 MB, RAID 6(ADG), OK) physicaldrive 1:3 (box 1:bay 3, Parallel SCSI, 4.3 GB, OK) physicaldrive 1:4 (box 1:bay 4, Parallel SCSI, 9.1 GB, OK) physicaldrive 1:5 (box 1:bay 5, Parallel SCSI, 9.1 GB, OK) physicaldrive 1:6 (box 1:bay 6, Parallel SCSI, 9.1 GB, OK) HP Array Configuration Utility 58