HP 2000-216NR HP 2000 Notebook PC - Maintenance and Service Guide - Page 52
protective sleeves must be installed on the antenna connectors
View all HP 2000-216NR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
3. Remove the WLAN module by pulling the module away from the slot at an angle (3). NOTE: The WLAN module is designed with a notch (4) to prevent incorrect installation into the WLAN module socket. NOTE: If the WLAN antennas are not connected to the terminals on the WLAN module, the protective sleeves must be installed on the antenna connectors, as shown in the following illustration. Reverse this procedure to install the WLAN module. 44 Chapter 4 Removal and replacement procedures
3.
Remove the WLAN module by pulling the module away from the slot at an angle
(3)
.
NOTE:
The WLAN module is designed with a notch
(4)
to prevent incorrect installation into the
WLAN module socket.
NOTE:
If the WLAN antennas are not connected to the terminals on the WLAN module, the
protective sleeves must be installed on the antenna connectors, as shown in the following illustration.
Reverse this procedure to install the WLAN module.
44
Chapter 4
Removal and replacement procedures