HP 2000-2a09CA HP 2000 Notebook PC and Compaq CQ58 Notebook PC - Maintenance a - Page 57
Remove the Phillips PM2.0×3.0 screw, WLAN module tilts up.
View all HP 2000-2a09CA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
To remove the WLAN module: 1. Loosen the memory module/wireless module compartment cover screw (1), and then lift up on the tab (2) and remove the cover (3). The memory module/wireless module compartment cover is available in the Plastics Kit. For more information about the Plastics Kit, see Plastics kit on page 23. 2. Disconnect the WLAN antenna cables (1) from the terminals on the WLAN module. NOTE: The #1 WLAN antenna cable is connected to the WLAN module Main terminal. The #2 WLAN antenna cable is connected to the WLAN module Aux terminal. 3. Remove the Phillips PM2.0×3.0 screw (2) that secures the WLAN module to the system board. (The WLAN module tilts up.) 4. Remove the WLAN module by pulling the module away from the slot at an angle (3). NOTE: If the WLAN antennas are not connected to the terminals on the WLAN module, the protective sleeves must be installed on the antenna connectors, as shown in the following illustration. ENWW Component replacement procedures 49