HP 3600 Service Manual - Page 193
Load Tray X <type> <size>, 5 Unexpected Type In Tray X - color laserjet firmware
View all HP 3600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 193 highlights
Control-panel message Description Recommended action To continue press A serial data error (parity, framing, or line overrun) occurred while the printer was receiving data. NOTE: Data will be lost. 40 EIO X BAD TRANSMISSION alternates with To continue press For the HP Color LaserJet 3000, 3800, and CP3505 Series printers with an EIO device only The connection with the card in the EIO slot has broken. Press to continue printing. NOTE: Data will be lost. 40 EMBEDDED I/O BAD TRANSMISSION alternates with The connection with the HP Jetdirect embedded print server has broken. Press to continue printing. To continue press 41.3 UNEXPECTED SIZE IN TRAY X alternates with LOAD TRAY X 41.5 UNEXPECTED TYPE IN TRAY X alternates with LOAD TRAY X 41.X ERROR alternates with To continue press 49.XXXXX ERROR alternates with To continue turn off then on Media is loaded that is longer or shorter in the feed direction than the size configured for the tray. The printer senses a different media type from what is configured in the tray. A printer error has occurred. X Description: 2 Beam-detected misprint error A critical firmware error has occurred. 1. Press to print from a different tray. 2. To print from the current tray, load the tray with the size and type indicated. Ensure that all trays are configured correctly before printing again. 1. Press to print from a different tray. 2. To print from the current tray, load the tray with the size and type indicated. 3. If the paper pickup has been replaced, perform a media-sensor calibration (see the instructions at the end of the Pickup-and-feed assembly on page 113 section). Ensure that all trays are configured correctly before printing again. 1. Press to continue or press for more information. 2. If the message persists after exiting the help, turn the printer off and then on. 1. Turn the printer off and then on. 2. Try printing a job from a different program. If the job prints, try printing a different file from the original program. If the message appears only with a certain program or print job, contact the software vendor for assistance. 3. If the message persists with different programs and print jobs, disconnect all of the printer cables that connect to the network or the computer. 4. Turn the printer off. ENWW Control-panel messages 181