HP 3PAR StoreServ 7400 4-node HP 3PAR StoreServ 7000 Storage Service Guide (QR - Page 48
Installing HP 3PAR OS Files, Beginning with HP 3PAR Service Processor Software 4.1.0 MU2
View all HP 3PAR StoreServ 7400 4-node manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
14. Verify the correct license is displayed and press Enter. If the license information is not correct, type c and press Enter to continue with the system setup. After completing the system setup, contact your local service provider for technical support to obtain the proper license keys. 15. Complete the network configuration: a. When prompted, type the number of IP addresses used by the system (usually 1) and press Enter. b. Type the IP address and press Enter. c. Type the netmask and press Enter. When prompted, press Enter again to accept the previously entered netmask. d. Type the gateway IP address and press Enter. e. Specify the speed and duplex and press Enter. Please specify speed (10, 100 or 1000) and duplex (half or full), or auto to use autonegotation: auto NOTE: If an NTP system IP address is not provided, use the SP IP address. f. Type the NTP system IP address and press Enter. g. If you indicated more than one IP address, the setup script prompts you to choose which nodes to use for each address. Note, are nodes (for example: 2 3 for nodes 2 and 3). Enter config for IP #0 IP Address: Netmask: Nodes Using IP address: h. Verify the IP address information is correct. Type y and press Enter. 16. The OOTB has completed when the following displays: Out-Of-The-Box has completed. Please continue with the SP moment of birth. Exiting Out-Of-The-Box Experience... Installing HP 3PAR OS Files After completing the Service Processor Setup wizard process, HP 3PAR OS files must first be installed onto the SP in order to communicate and add a storage system. NOTE: If the StoreServ is previously setup before the SP, do not use the SP Setup Wizard. Beginning with HP 3PAR Service Processor Software 4.1.0 MU2, the SP Setup Wizard expects the StoreServ to be in a non-initialized state. As a result, use SPMOB (SP console) method to set up the SP. The SPMOB allows you to ignore StoreServ verification failures during SP setup because the SmartStart SP Setup Wizard prevents the bypassing of the verification operation. To install the OS files: 1. Insert the HP 3PAR OS Release Distribution CD into the SP. 2. Log in to the SP as spvar (password prompted). 3. In the SPMAINT main menu, type: • 1 for SP Control/Status • 16 for Maintain SP Software 48 Installing Storage Software Manually