HP 4400 HP Controller Enclosure Battery Replacement Instructions (593090-001,
HP 4400 Manual
 |
View all HP 4400 manuals
Add to My Manuals
Save this manual to your list of manuals |
HP 4400 manual content summary:
- HP 4400 | HP Controller Enclosure Battery Replacement Instructions (593090-001, - Page 1
hp.com/support/ manuals, and select your product. The information contained herein is subject to change without notice. The only warranties for HP products and services in place in the enclosure until a new module is available to install. • Port-colored (purple) handles on components like the battery - HP 4400 | HP Controller Enclosure Battery Replacement Instructions (593090-001, - Page 2
HP Insight Remote Support Software provides a recommended fault monitoring solution. • Check the battery status using HP window. will fail over when one hand under the battery module, and with the other hand, pull the battery out of the enclosure. Figure 3 Removing a battery module . Installing
-
1 -
2
 |
 |
HP Controller Enclosure Battery
Replacement Instructions
© Copyright 2009 Hewlett-Packard Development Company, L.P.
Second edition: May 2011
The information in this document is subject to change without notice.
Printed in Puerto Rico
www.hp.com
*593090-001*
About this document
For the latest documentation, go to
h
t
tp://w
w
w
.hp
.co
m/su
ppo
r
t/
man
uals
, and select your product.
The information contained herein is subject to change without notice.
The only warranties for HP products and services are set forth in the
express warranty statements accompanying such products and services.
Nothing herein should be construed as constituting an additional
warranty. HP shall not be liable for technical or editorial errors or
omissions contained herein.
WARRANTY STATEMENT:
To obtain a copy of the warranty for this product, see the warranty
information website:
h
t
tp://w
w
w
.hp
.co
m/go/s
t
o
r
age
w
ar
r
an
t
y
Before you begin
Observe the following precautions when replacing the battery module.
CAUTION:
Removing a battery module significantly changes the air flow
within the enclosure. Both modules must be installed for the
enclosure to cool properly. If a single battery module fails, leave
it in place in the enclosure until a new module is available to
install.
•
Port-colored (purple) handles on components like the battery module
means the component is hot-swappable. The battery can be removed
and replaced without having to power the system down.
•
There are two battery modules under the bezel on the front of the
controller enclosure. See
Figure 1
for the locations. Each battery
provides power to the controller directly across from it in the enclos-
ure. Battery 1 (B1) provides power to controller 2 (C2) and battery
2 (B2) provides power to controller 1 (C1).
•
Your controller enclosure model may vary slightly from what is illus-
trated in this document.
Page 1