HP 4400 HP Controller Enclosure Cache DIMM Replacement Instructions (593091-00 - Page 4
Verifying proper operation - install
View all HP 4400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
4. Reinstall the controller: a. Push the controller halfway into the controller enclosure (1, Figure 9). b. Attach the Fibre Channel and/or SAS (if applicable) cables to the controller. c. Fully insert the controller. Move the mounting latch to the left until fully engaged and the controller is fully seated in the enclosure (2, Figure 9). The controller should power up automatically. NOTE: Inserting a controller without connecting the cables may result in soft diagnostic errors being reported. Figure 9 Installing a controller . Verifying proper operation After replacing the controller, check the following to verify the component is operating properly: NOTE: Wait approximately three minutes for the system to check the component status. • Verify the controller health green LED is lit (see Table 1). If not, try reseating the controller in the enclosure. • From HP P6000 Command View, navigate to the component as described in the Verifying component failure section, and check the status. It should be (Good). Page 4