HP 4400 HP Controller Enclosure Fan Module Replacement Instructions (593092-00
HP 4400 Manual
 |
View all HP 4400 manuals
Add to My Manuals
Save this manual to your list of manuals |
HP 4400 manual content summary:
- HP 4400 | HP Controller Enclosure Fan Module Replacement Instructions (593092-00 - Page 1
Enclosure Fan Module Replacement Instructions About this document For the latest documentation, go to http://www.hp.com/support/ manuals, and select your product. The information contained herein is subject to change without notice. The only warranties for HP products and services are set forth - HP 4400 | HP Controller Enclosure Fan Module Replacement Instructions (593092-00 - Page 2
following methods to verify component failure: • Analyze any failure messages received. HP Insight Remote Support Software provides a recommended fault monitoring solution. • Check the fan status using HP P6000 Command View: 1. In the Navigation pane, select Storage system > Hardware > Controller
-
1 -
2
 |
 |
HP Controller Enclosure Fan
Module Replacement Instructions
© Copyright 2009 Hewlett-Packard Development Company, L.P.
Second edition: May 2011
The information in this document is subject to change without notice.
Printed in Puerto Rico
www.hp.com
*593092-001*
About this document
For the latest documentation, go to
h
t
tp://w
w
w
.hp
.co
m/su
ppo
r
t/
man
uals
, and select your product.
The information contained herein is subject to change without notice.
The only warranties for HP products and services are set forth in the
express warranty statements accompanying such products and services.
Nothing herein should be construed as constituting an additional
warranty. HP shall not be liable for technical or editorial errors or
omissions contained herein.
WARRANTY STATEMENT:
To obtain a copy of the warranty for this product, see the warranty
information website:
h
t
tp://w
w
w
.hp
.co
m/go/s
t
o
r
age
w
ar
r
an
t
y
Before you begin
Observe the following precautions when replacing a fan module.
CAUTION:
Removing a fan module significantly changes the air flow within
the enclosure. Both fan modules must be installed for the
enclosure to cool properly. Do not remove both fans
simultaneously with the enclosure powered on. If a single fan
module fails, leave it in place in the enclosure until a new fan
is available to install. The remaining fan module will speed up
and allow operation for a limited time based on operating and
environmental conditions. If a temperature threshold is
exceeded, the enclosure automatically shuts down.
Parts can be damaged by electrostatic discharge. Use proper
anti-static protection. Refer to the documentation that shipped
with your system for additional information.
•
Port (purple)-colored handles on components like the fan module in-
dicate the component is hot-swappable. This fan module can be re-
moved and replaced without having to power the system down.
•
There are two fan modules under the bezel on the front of the con-
troller enclosure. See
Figure 1
for the locations.
•
Your controller enclosure model may vary slightly from what is illus-
trated in this document.
2. Fan 2
1. Fan 1
Figure 1 Fan module locations
.
Page 1