HP 600N HP JetDirect 600N Print Server Hardware Installation Guide - 5969-6858 - Page 18
Step 2. If Necessary, Set Switches or Jumpers on Your Card, Step 2
UPC - 088698541357
View all HP 600N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Step 2. If Necessary, Set Switches or Jumpers on Your Card G If you have an HP J3112A Token Ring print server, you must set the Data Rate switches on the card to either 4 Mbps or 16 Mbps. The selection depends on the data rate of your Token Ring network. 4 Mbps 16 Mbps a. Locate the Token Ring card Data Rate switches. b. Set the switches to 4 or 16 Mbps. The default is 16 Mbps. G If you have an HP J3113A 10/100Base-TX print server, verify that jumper P1 is in the "AUTO" (Autonegotiation) position. This is the default position. (In this position, the card will attempt to automatically connect to the network at the detected speed (10 or 100 Mbps) and communication mode (Full or Half Duplex).) P1 = AUTO 10/100; Half/Full Autonegotiation Note For the definition of other jumper settings on the 10/100Base-TX card, see appendix A. 2-4 Installing the Print Server