HP 8/40 Brocade Fabric OS Command Reference Manual v6.2.0 (53-1001186-01, Apri - Page 152

2 cryptoCfg Note All EEs in the encryption group must be interconnected through a dedicated local area network (LAN), preferably on the same subnet and on the same VLAN using the GbE Ports on the encryption switch or blade. The two GbE Ports of each member node (Eth0 and Eth1) should be connected to the same IP Network, the same subnet, and the same VLAN. Configure the GbE Ports (I/O sync links) with an IP address for the eth0 Ethernet interface, and also configure a gateway for these I/O sync links. Refer to the ipAddrSet help page for instructions on configuring the Ethernet interface. These I/O sync link connections must be established before you enable the EEs for encryption. If these configuration steps are not performed, you cannot create an HA cluster, perform a first-time encryption, or initiate a re-keying session. Operands The cryptoCfg group configuration function has the following operands: --help -groupcfg Displays the synopsis for the group configuration function. This command is valid on all nodes. --create -encgroup Creates an encryption group. The node on which this command is invoked becomes the group leader. You must specify a name when creating an encryption group. encryption_group_name Specifies the name of the encryption group to be created. The name can be up to 15 characters long and include alphanumeric characters and underscores. White space, hyphens, and other special characters are not permitted. --delete -encgroup Deletes an encryption group with the specified name. This command is valid only on the group leader. This command fails if the encryption group has more than one node, or if any HA cluster configurations, CryptoTarget container/LUN configurations, or tape pool configurations exist in the encryption group. Remove excess member nodes and clear all HA cluster, CryptoTarget container/LUN, or tape pool configurations before deleting an encryption group. encryption_group_name Specifies the name of the encryption group to be deleted. This operand is required when deleting an encryption group. --reg -keyvault cert_label Registers the specified key vault (primary or secondary) with the encryption engines of all nodes present in an encryption group. Upon successful registration, a connection to the key vault is automatically established. This command is valid only on the group leader. Registered certificates are distributed from the group leader to all member nodes in the encryption group. Each node in the encryption group distributes the certificates to their respective encryption engines. The following operands are required when registering a key vault: Specifies the key vault certificate label. This is a user-generated name for the specified key vault. Use cryptocfg --show -groupcfg to view the key vault label after registration is complete. 124 Fabric OS Command Reference 53-1001186-01