HP 8/40 Brocade Fabric OS Command Reference v6.3.0 (53-1001337-01, July 2009) - Page 773
Trunk Utilization, Operands, e-port, fop-port, C3TX_TO
View all HP 8/40 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 773 highlights
portThConfig 2 For more information on port threshold configuration procedures, including default values for specific area high/low thresholds, refer to the Fabric Watch Administrator's Guide. Operands This command has the following operands: --set Configures the Fabric Watch thresholds for monitoring a specified area for all ports of a specified port type. When configuring a threshold, you must specify a port type and area. --show Displays the threshold configuration or run-time status for all configured port types and areas. You can optionally specify a port type to display the threshold for ports of that type only. Or you can specify an area to display the area-specific configuration only. When issued without operands, this command displays all configured thresholds for all port types. port_type the following operands are required with the --set option and are optional with the--show options. Specifies the port type for which to configure or display FabricWatch settings or current status. Valid port types include one of the following: e-port Configures or displays all E_Ports. fop-port Configures or displays all optical F_Ports. Configuring copper F_Ports is currently not supported. -area area port Configures or displays all physical ports. Specifies the area monitored by the Fabric Watch daemon. The following areas are valid when configuring or displaying configuration settings on E_Ports, optical F_Ports, and physical ports. Area values are not case-sensitive. CRC Cyclic redundancy check error ITW Invalid transmission word C3TX_TO Class 3 discards frames due to timeout (8 G platforms only) LOS Loss of synchronization LF Link failure RX Receive error TX Transmit error PE Protocol error LR Link reset ST State change TU Trunk Utilization ve-port Specifies the port type to be configured as a VE_Port. Only a subset of areas can be configured for this port type. -area ve_port_area Specifies the area to be configured or displayed for a VE_Port. Configurable areas for VE_Ports include the following: Fabric OS Command Reference 743 53-1001337-01