HP 8550mfp Service Manual - Page 90

Configuration Menu Table 20. Configuration Menu Item POWERSAVE= PERSONALITY= Value 30 MIN 1 HOUR* 2 HOURS (8500 only) 3 HOURS 8 HOURS (8550 and some 8500 models) 10 SEC AUTO* PCL PS CLEARABLE WARNINGS= ON* JOB TONER LOW= CONTINUE* STOP NEW TONER CARTRIDGE= (8550 only) QUICK COPY JOBS = (8550 only) PRINT PS ERRORS= NO YES 0 to 50 OFF* ON INITIALIZE DISK None * Default setting. Description/action Sets the length of time after use before the printer switches to powersave mode. Note that the 10-second setting is for service personnel use. Allows the user to determine which personality will be the default for the printer. When AUTO is selected, the printer will determine which personality to use for each print job. Note: PCL support is not available at initial product introduction. Determines the amount of time that a clearable warning is displayed on the printer control panel. If set to ON, then clearable warnings are displayed until GO is pressed. If set to JOB, then clearable warnings are displayed until the end of the print job. Determines the printer response to consumable low and out messages (including TONER LOW, TRANSFER KIT OUT, FUSER LIFE OUT, and DRUM LIFE LOW). If set to CONTINUE, clear the message by pressing GO. If set to STOP, clear the message by replacing the consumable. The default is 32. If the PostScript interpreter detects illegal commands, the job is canceled. If ON, an error page prints. If OFF, there is no indication that an error occurred. Appears only if the appropriate printer hard disk is installed. Press SELECT to initialize. 88 Chapter 3 - Operational overview EN