HP A180 HP DLPI Programmer's Guide - Page 128
DL_HP_CLEAR_STATS_REQ, New State, Response, Reasons for Failure, Format, Parameters
![]() |
View all HP A180 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 128 highlights
DLPI Primitives Connection-mode Service Primitives The message is valid in the states DL_IDLE, DL_DATAXFER, DL_OUTCON_PENDING, DL_INCON_PENDING, DL_USER_RESET_PENDING, and DL_PROV_RESET_PENDING. New State The resulting state is unchanged. Response If the specified dl_remote_win is valid and the primitive was issued from a valid state, the DLS provider responds with a DL_OK_ACK. Otherwise a DL_ERROR_ACK is returned. Reasons for Failure DL_OUTSTATE Primitive was issued from an invalid state. DL_SYSERR If the specified dl_remote_win is invalid, then a DL_ERROR_ACK with dl_errno set to DL_SYSERR and dl_unix_errno set to EINVAL is returned. The UNIX error returned may be set to (not limited to) errors listed in Table 2-2 on page 71. DL_HP_CLEAR_STATS_REQ Requests the DLS provider to zero the mem_fails, queue_fails, ack_to_cnt, p_to_cnt, rej_to_cnt, busy_to_cnt, i_pkts_in, i_pkts_in_oos, i_pkts_in_drop, i_pkts_out, i_pkts_retrans, s_pkts_in, s_pkts_out, u_pkts_in, u_pkts_out, bad_pkts, max_retry_cnt, remote_busy_cnt, and hw_req_fails statistics which are reported in the DL_HP_INFO_ACK primitive. Format typedef struct { u_long dl_primitive; } dl_hp_clear_stats_req_t; Parameters dl_primitive DL_HP_CLEAR_STATS_REQ 128 Chapter 2
![](/manual_guide/products/hewlettpackard-rp5405-hp-dlpi-programmers-guide-0ec5ab3/128.png)